SDC 539 Monitoring Switch Kit Instruction Manual
- June 3, 2024
- SDC
Table of Contents
SECURITY DOOR CONTROLS ■
WWW.SDCSECURITY.COM
[t] 800.413.8783 ■ 805.494.0622 ■ E-mail: service@sdcsecurity.com ■ 801 Avenida Acaso, Camarillo, CA 93012 ■ PO Box 3670, Camarillo, CA 93011
INSTALLATION INSTRUCTIONS
539
MONITORING SWITCH KIT
CAL-ROYAL 9800 SERIES
WIRING SPECIFICATION
ORG – N/C
WHT – COM
YEL – N/O
5 AMP MAX
Applications
Remote Latch Status Monitoring:
Retracting the latch by depressing the push pad provides an output signal for
local or remote visual and audible annunciation indicating forced entry or
unauthorized egress.
Access Control REX: When connected to the Request-To-Exit input of a keypad, card or biometric Access Controller, depressing the pushpad and retracting the latch actuates the Latch Status contact, shunting the control access control alarm to permit authorized egress and/or releases the magnetic door lock for uninhibited egress.
Magnetic Lock Release: Where Access Controller with REX input is unavailable, the N/C contact of the switch is wired in series between the power supply and fail safe magnetic lock. Depressing the exit device pushpad retracts the latch, causing the contact to open, thereby releasing the magnetic lock for uninhibited egress.
Mantrap Logic: Provides N/O and N/C contacts required for 2 or more communicating doors for Interlock and Mantrap applications.
Any suggestions or comments to this instruction or product are welcome. Please contact us through our website or email engineer@sdcsecurity.com
P:\INST INSTRUCTIONS\EGRESS CONTROLS\INST-539 REV B 07-21
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>