OKIN CU170 Control Unit User Guide
- June 6, 2024
- OKIN
Table of Contents
How to Sync Two Bases
CU170
-
Plug both bases into a power source.
Operate each base with its respective remote control to verify the base functions properly.
NOTE
Make sure both remotes are in “press & hold” mode before beginning procedure -
Lower both bases to the flat position and unplug them from outlet.
-
Place both bases on their sides close to each other.
CAUTION:
DUE TO RISK OF INJURY, TWO ADULTS ARE REQUIRED TO HANDLE AND MOVE THE ADJUSTABLE BASE. -
Locate the sync cable.
-
Unplug the underbed light plug from the MFP of the control box on both bases, then insert one male plug of sync cable into the MFP of base 1 control box and the other male plug of sync cable into the MFP of base 2 control box.
-
Insert the underbed light plug from base 1 into one female plug of the sync cable, then insert the underbed light plug from base 2 into the other female plug of the sync cable.
-
Turn both bases over onto their legs.
CAUTION:
DUE TO RISK OF INJURY, TWO ADULTS ARE REQUIRED TO HANDLE AND MOVE ADJUSTABLE BASE. -
Plug both bases back into power outlet.
-
Operate the remote control(s) to verify both bases function in unison. If using only one remote control to operate both bases, store the second remote for use as a spare.
NOTE
If bases do not operate in unison with the remote, verify dual sync cable connections are fully seated in both MFP ports. Unplug both bases, wait 10 seconds, then plug them back in.
292-0041-D EDR 16023 4/21