OKIN CB1322 Control Box User Manual

OKIN CB1322 Control Box

Electrical configuration diagram

Function PictureProcess of test

1. HEAD
   Connect to head actuator,control by remote single: Click head up button on the remote, head actuator moves out, stop when released； Click head down button，head actuator moves in, stop when released； This function takes effect only by pressing the corresponding button on the remote.

2. FOOT
   Connect to foot actuator,control by remote single: Click foot up button，foot actuator moves out，stop when released； Click foot down button，foot actuator moves in，stop when released； This function takes effect only by pressing the corresponding button on the remote.

3. Massage
   Connect to head & Foot massage,control by remote: Click head massage + button,head massage strengthens by one level; Click head massage – button,head massage weakenby one level; This function takes effect only by pressing the corresponding button on the remote.

4. MFP2
   Connect to WIFI box or Bluetooth or anyother device。

5. underbed light
   Click button of underbed light, turns on( or turns off ) the underbed light, switch the status once when click once； This function takes effect only by pressing the corresponding button on the remote.

6. SYNC port
   Connect with the same other Control box or Other accessories;

7. Power LED & PAIRING LED
   Power supply for control box, PAIRING LED of control box is blue, POWER LED is green。

8. Power
   Connect to the 29V DC;

9. Pair button
   Press and hold the Pair button，the Head, Foot actuators will moves to lower position.
   

10. Pair Function
    Double click Pair button，pairing LED turns on，the control box enters into mode of code paring； Press and hold the paring LED of Remote, the backlight of paring LED flashes, the backlight of remote flashes, the remote enters into mode of code paring; The backlight of paring LED of remote stops flashing, and the paring led of control box turns off, it indicates that the code paring is successful; If fails, repeat all the processes above;
    

11. MFP1
    Connect to slide switch
    

Federal Communications Commission (FCC) Statement

You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation of the device.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.

Canada, Industry Canada (IC) Statement

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:

1. this device may not cause interference, and
2. this device must accept any interference, including interference that may cause undesired operation of the device.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>