FRYCLONE 259FLTRP70 Portable Oil Filter Machine User Manual

FRYCLONE 259FLTRP70 Portable Oil Filter Machine User Manual

SPECIFICATIONS

MODEL| VOLTAGE| POWER| WEIGHT| WIDTH| DEPTH| HEIGHT
---|---|---|---|---|---|---
259FLTRP70| 120V • 60Hz| 4 Amps| 19.4 lb| 7 5/8″| 12 1/4″| 19″

SAFETY

As is the case with most cooking equipment, your shortening filter should be used with caution. Please read the following warnings to avoid potential injuries.

WARNING

CAN CAUSE SERIOUS INJURY OR DEATH.

DO NOT ATTEMPT TO SERVICE THIS EQUIPMENT UNLESS YOU ARE A LICENSED ELECTRICIAN OR TRAINED SERVICER .

• Because this equipment utilizes high voltage, it should only be installed and serviced by a licensed electrician or trained servicer. Attempting to install or service the equipment yourself could result in serious, potentially fatal
• If an electrical shock is felt when touching equipment, shut off power immediately (pull cord or turn off circuit breaker) and call a trained servicer for repair. Failure to do so could result in serious, potentially fatal
• Always turn power switch off any time the equipment is not in

WARNING

Improper installation, adjustment, alteration, service, or maintenance can
cause property damage, injury, or death. Read the installation, operating, and maintenance instructions thoroughly before installing or servicing this equipment.

CAUTION This equipment is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the equipment by a person responsible for their safety.
CAUTION Children should be supervised to ensure that they do not play with the equipment.
CAUTION This equipment is intended to be used for commercial applications, for examplein kitchens of restaurants, canteens, hospitals, and in commercial enterprises such as bakeries, butcheries, etc., but not for continuous mass production of food.
CAUTION These models are designed, built, and sold for commercial use only. If these models are positioned so the general public can use the equipment, make sure that cautions, warnings, and operating instructions are clearly posted near each unit so that anyone using the equipment will use it correctly and not injure themselves or harm the equipment.

Fryclone will not accept liability for product failures in the event that:

• The instructions in this manual have not been followed
• Unqualified personnel have adjusted the Fryclone Filter
• Non-original spare parts are

PACKAGING

All Fryclone products are inspected and tested prior to packing. If any of the following parts are found to be missing or damaged after transit, you must contact your supplier immediately

DESCRIPTION

1. Power indicator (red LED)
2. Filtration indicator (green LED)
3. Start/Stop button
4. Drip pan
5. Star handles (both sides)
6. Control Unit
7. Handles
8. Power cord
9. Pump-Filter unit
10. Vent Slots
11. Cable protection
12. Control panel

SETUP

Remove the Oil Filter from the packaging, ensuring that all protective packaging, plastic, and residues are cleaned from its surfaces. Lay out all components of the Oil Filter on a table to prepare for assembly.

GUIDELINES FOR USE

STEP 1

Take the control unit “6” and place it on top of the pump filter unit “9.”

STEP 2

Tighten the star handles “5” on both sides until snug.

STEP 3

Ensure there is filter paper installed in the pump filter unit “9.” Once paper is installed you are ready to filter. Refer to page 4 for filter instructions.

WARNING

DO NOT operate appliance unless filter paper has been installed. Designed to be used on commercial fryer oil only.

FILTRATION

This appliance is intended for professional use only and should be operated by fully trained and qualified personnel. This appliance is intended for indoor use only.
CAUTION Prior to using this equipment for the first time, perform the daily cleaning procedure on page 5.

WARNING

SERIOUS INJURY OR PROPERTY DAMAGE CAN OCCUR

IF PROPER PRECAUTIONS ARE NOT FOLLOWED

• DO NOT use Fryclone to clean/filter of liquids other than frying
• DO NOT use Fryclone
• DO NOT filter more than (4) fryers There is a risk of overheating/fire hazard.
• DO NOT use the electrical cord as a leash to move the
• DO NOT cover the vents on the filter
• DO NOT operate this machine with wet

GUIDELINES FOR USE

1. Clean FRYCLONE prior to using for the first time (see cleaning instructions on page 5).
2. Ensure the FRYCLONE FILTER is properly assembled (see setup instructions on page 3).
3. Turn off the fryer you are about to clean and let the oil cool
4. DO NOT run the FRYCLONE FILTER outside of the
5. Maximum temperature the FRYCLONE FILTER can withstand is 392 degrees
6. Do not place FRYCLONE FILTER on top of fryer heating
7. To transport FRYCLONE FILTER only pick it up by the
8. Do NOT let the power cord (8) or control unit (6) come in contact with hot
9. Filter duration is 5 minutes per cycle with a max of 4 cycles (once maximum cycles have been reached the unit must cool down for 2 hours prior to next use).

OPERATION

1. Place the FRYCLONE FILTER in the deep
2. Ensure that FRYCLONE FILTER stands
3. Check the frying oil level (take care of MIN and MAX levels).
4. Plug in the power cord (8). Power indicator (1) lights
5. Press Start / Stop button (3). The filter indicator (2) lights up during
6. Once filter cycle is complete unplug the FRYCLONE FILTER and place in drip pan (4).
7. Change filter paper as needed (max of 10 filtrations per paper

IF you need to stop the filtration prematurely press the start/stop button (3) and then lift the FRYCLONE FILTER and let residual oil flow into fryer.

CLEANING & MAINTENANCE

WARNING

SERIOUS INJURY OR PROPERTY DAMAGE CAN OCCUR

IF PROPER PRECAUTIONS ARE NOT FOLLOWED

• The power supply must be disconnected before servicing, maintaining, or cleaning this machine.
• DO NOT pump water through the filter pump The pump functions using the lubrication of oil and using water will damage the pump.
• DO NOT clean the FRYCLONE FILTER if it has not had sufficient time to cool down.
• DO NOT attempt to circulate water through Internal rusting in pump will occur.
• DO NOT use abrasive cleaners, wire brush, or similar items to clean
• If the supplied power cord or receptacle is damaged, it MUST be replaced by an authorized service and parts company technician in order to avoi a hazard.

NOTE: Follow these cleaning instructions before using machine for the first time.
NOTE: Shortening Filter must be cleaned DAILY. Failure to do so will void warranty.
NOTE: Clean the pump-filter unit (9) every time the filter paper is changed.

PREPARING FOR CLEANING

1. Make sure that FRYCLONE FILTER has cooled
2. Loosen the star handles (5) (on both sides).
3. Detach the control unit (6) from the pump-filter unit (9).
4. Open the pump-filter unit (9).
5. Remove and dispose of the filter
6. Manual cleaning or cleaning with the

Boil out:

If the pump-filter unit (9) is heavily soiled, deep clean it with water and soap or deep fryer cleaner.
Regular boil outs are recommended for optimal cleaning and maintenance results.

Cleaning with Dishwasher:

Clean the control unit (6) only with a damp cloth!
NEVER put the control unit (6) in the dishwasher! This will damage the unit. Put the pump-filter unit (9) and the drip tray (4) into the dishwasher.
Start the cleaning program.

Manual Cleaning:

Clean the control unit (6) with a damp cloth!
DO NOT use running water! This will damage the control unit! Wash the pump- filter unit (9) and the drip tray (4).
Dry FRYCLONE FILTER.

REPLACING FILTER PAPER

1. Ensure the FRYCLONE FILTER is
2. Lift up the compartment on the pump-filter unit (9) where the filter paper is housed (image below).
3. Remove old paper and replace with new FRYCLONE FILTER
4. Overlap the last fold on both sides of the pump-filter unit (do not leave gaps between the filter and the edges of the unit).
   

The WEEE logo on this product or its documentation indicates that the

product must not be disposed of as household waste. To help prevent possible harm to human health and/or the environment, the product must be disposed of in an approved and environmentally safe recycling process. For further information on how to dispose of this product correctly, contact the product supplier, or the local authority responsible for waste disposal in your area.
Fryclone parts have undergone strict product testing in order to comply with regulatory standards and specifications set by international, independent, and federal authorities. Fryclone products have been approved to carry the following symbols:

TROUBLESHOOTING

WARNING

SERIOUS INJURY OR PROPERTY DAMAGE CAN OCCUR

IF PROPER PRECAUTIONS ARE NOT FOLLOWED

• The power supply must be disconnected before servicing, maintaining, or cleaning this machine.
• If the supplied power cord or receptacle is damaged, it MUST be replaced by an authorized service and parts company technician in order to avoid a hazard.

Power indicator (red LED)

(1) remains inactive

| Power cord (8) not plugged in| Plug in FRYCLONE FILTER
Power cord (8) defective| Please contact service
Device defective| Please contact service
FRYCLONE FILTER is very noisy during operation| Star handles (5) are loose| Tighten star handles (5)
Rotor defective| Please contact service
Rotor scratches on the fryer| Change the position of FRYCLONE FILTER in the deep fryer
Power indicator (red LED) (1) flashes| Overtemperature| Let FRYCLONE FILTER cool down
FRYCLONE FILTER doesn’t start| Control unit (6) defective| Please contact service
Power cord (8) or other electrical components defective| Please contact service
Line fuse / Ground fault circuit fuse (GFCI) blow-out| Rotor defective / blocked| Please contact service
Circuit overloaded| Change socket/circuit
Low filtration performance| Particle filter is full| Change particle filter
Pump-filter unit (9) clogged| Empty pump-filter unit (9) & boil out to remove heavy contamination
Motor defective| Please contact service
Oil splashed sideways and / or at the back of the pump-filter unit (9)| Particle filter full| Change particle filter
Too much space between filter cover and pump-filter unit (9)| Please contact service
Filter paper not inserted / overlapping| Insert particle filter as described in user manual
Power and filter indicator (1 & 2) flash **and alternating acoustic signal 10 sec. after plugging FRYCLONE FILTER in| Start / Stop button (3) defective| Please contact service
Control unit (6) wet inside| Please let it dry
Power and filter indicator (1 & 2) flash **and continuous acoustic signal| FRYCLONE FILTER is tilted more than 15°, Strong vibrations| Check position of FRYCLONE FILTER Defective rotor or motor

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>