OKIN RF402A Remote Control User Manual

: June 4, 2024
: OKIN

Table of Contents

COMPONENTS
- Head up 1
- Head down 2
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Issue Department: Bedding Division
Date: 2022-07-19
Author
User Manual
Edition: 1.1

RF402A

Figure 1 button of remote

COMPONENTS

Head up
Head down

Item

Head up 1

Press and hold HEAD UP button of remote, the control box receives the signal and controls the head motor through the linehead motor moves out, stop when released

Head down 2

Press and hold HEAD DOWN button of remote, the control box receives the signal and controls the head motor through the line, head motor moves in, stop when released

Description
Product name: Remote Control
Model name: RF402A
Frequency Range:2403-2480MHz
Antenna Specification:PCB Antenna/1dBi
Power supply:3Vdc

Federal Communications Commission (FCC) Statement
You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

this device may not cause harmful interference, and
this device must accept any interference received, including interference that may cause undesired operation of the device.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

RF warning for Portable device:
The device has been evaluated to meet general RF exposure requirment. The device can be used in portable exposure conditions without restriction.

Canada, Industry Canada (IC) Statement
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:

his device may not cause interference, and
this device must accept any interference, including interference that may cause undesired operation of the device.

ISED RF exposure statement:
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. The device has been evaluated to meet general RF exposure requirement.