DEWERT OKIN FP.08.08.01 KiKi User Manual
- June 3, 2024
- DEWERT OKIN
Table of Contents
DEWERT OKIN FP.08.08.01 KiKi
Keyboard
Long press to pair box
- The box is powered on, and the blue LED lights on to enter the pairing mode
- Press and hold the offline voice button for 3 seconds until it flashes.
If the pairing is successful, the LED light stops flashing and turns on. If pairing fails, the blue LED light turns off. Repeat the steps until pairing is successful
Short press to stop function
Click the Press button to stop all actions
Command Function
To activate VCM, say the wake words, “Okay, Bob.” The LED light on the device lights up green and the Voice Command Module responds with a “beep.”
NOTES : The VCM is set in silent as its default mode. When the voice feedback is turned on and after every successful command, the VCM responds with “I am here.”
Within 15 seconds, say the voice command to control your bed. Your adjustable bed beeps again and adjusts according to a valid voice command.
NOTE : It is not necessary to repeat the wake word. The VCM responds automatically when given a different command.
To toggle through the wake words, say “Switch to Bob/Jarvis/Coco/Austin/Dan/Ruby.” The Voice Command Module responds with “Bob/Jarvis/Coco/Austin/Dan/Ruby is now ready. You can say ‘Okay, Bob/Jarvis/Coco/Austin/Dan/Ruby’ to wake me up.”
Command
Serial n
umber
| Command| Feedback| Action
---|---|---|---
1| HEAD-UP| HEAD-UP| Raises the head section of the bed.
2| HEAD-DOWN| HEAD-DOWN| Lowers the head section of the bed
3| FOOT-UP| FOOT-UP| Raises the foot section of the bed.
4| FOOT-DOWN| FOOT-DOWN| owers the head section of the bed
5| NECK-UP| NECK-UP| Raises the neck section of the bed
6| NECK-DOWN| NECK-DOWN| Lowers the neck section of the bed
7| LUMBAR-UP| LUMBAR-UP| Raises the lumbar section of the bed.
8| LUMBAR-DOWN| LUMBAR-DOWN| Lowers the lumbar section of the bed
9| STOP-ALL| STOP-ALL| Stops all lift activities
10| FLAT-POSITION| FLAT-POSITION| Adjusts the bed into a flat position.
11| ****
ZERO-GRAVITY
| ****
ZERO-GRAVITY
| Raise the foot section slightly higher than the
chest for a relaxing position.
12| ****
LOUNGE-POSITION
| ****
LOUNGE-POSITION
| Adjusts the bed into a relaxing chaise lounge
position.
---|---|---|---
13| ANTI-SNORE| ANTI-SNORE| Raises the head section to help reduce snoring
14| MASSAGE-START| MASSAGE-START| Turns massage motors on.
15| MASSAGE-STOP| MASSAGE-STOP| Turns massage motors off
16| WAVE-ONE| WAVE-ONE| Starts massage at wave 1.
17| WAVE-TWO| WAVE-TWO| Starts massage at wave 2
18| WAVE-THREE| WAVE-THREE| Starts massage at wave 3.
19| WAVE-FOUR| WAVE-FOUR| Starts massage at wave 4
20| MASSAGE-UP| MASSAGE-UP| Increases massage intensity
21| MASSAGE-DOWN| MASSAGE-DOWN| Decreases massage intensity
22| LIGHT-ON| LIGHT-ON| Turns the underbed lights on.
23| LIGHTS-ON| LIGHTS-ON| Turns the underbed lights on.
24| LIGHT-OFF| LIGHT-OFF| Turns the underbed lights off.
25| LIGHTS-OFF| LIGHTS-OFF| Turns the underbed lights off.
26| TOGGLE-LIGHT| TOGGLE-LIGHT| Toggles through the underbed light colors
27| TOGGLE-LIGHTS| TOGGLE-LIGHTS| Toggles through the underbed light colors
28| VOLUME-UP| VOLUME-UP| Increases the volume of the VCM.
29| VOLUME-DOWN| VOLUME-DOWN| Reduces the volume of the VCM
30| ****
MAX-VOLUME
| ****
MAX-VOLUME
| Increases the volume of the VCM to the
maximum level.
31| ****
MINIMUM-VOLUME
| MINIMUM-VOLUME| Reduces the volume of the VCM to the
minimum level.
32| SILENT-MODE| SILENT-MODE| akes “dingdong” as a voice feedback
33| TURN-ON-SOUND-PLA
YBACK
| TURN-ON-SOUND-PLAY
BACK
| Turns on the voice feedback again
FCC Statement
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment .This equipment should be installed and operated with
minimum distance 20cm between the radiator& your body.
Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
ISED RSS Warning/ISED RF Exposure Statement
ISED RSS Warning:
This device complies with Innovation, Science and Economic Development Canada
licence-exempt RSS standard(s). Operation is subject to the following two
conditions:
- this device may not cause interference, and
- this device must accept any interference, including interference that may cause undesired operation of the device.
ISED RF exposure statement:
This equipment complies with ISED radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator& your body.This transmitter must
not be co-located or operating in conjunction with any other antenna or
transmitter.