ROBUS RCA244012E-01 24W 1.2M Caesar IP20 LED Batten Instruction Manual
- June 6, 2024
- ROBUS
Table of Contents
INSTRUCTION MANUAL
CAESAR IP20 LED BATTEN, 4000K, EMERGENCY
RCA244012E-01 24W 1.2M
RCA484012E-01 48W 1.2M
RCA484015E-01 48W 1.5M
RCA804015E-01 80W 1.5M
PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE
REFERENCES.
! Electrical products can cause death or injury, or damage to property. If in
any doubt about the installation or use of this product, consult a competent
electrician
Note: Product technical information and specification may change over
time without prior notification. For the latest technical information please
visit our web site www.robus.com or
robusdirect.com
-10°C < Ta < +40°C, 220V – 240V ~ 50/60Hz, Class I, IP20, Battery Warranty: 2 Years
Luminaire is non-dimmable Suitable for mounting on a normally flammable
surface.
Installation
- Ensure mains supply is switched off before commencing work.
- Select suitable location for mounting luminaire
- Expose the base by removing the screws.
- Remove diffuser/ LEDs from base. Unplug Connector
- Write installation date on battery and connect battery
- Mark appropriate fixing hole positions on wall, check location of buried cables, pipes and other building services before drilling
- Feed supply cables through cable entry hole and attach base to surface
- Connect wires from un-switched supply to terminals: Brown/Live to PL, Blue/ Neutral to N and Green/ Yellow to earth. For fitting always on, link terminal “SL” to terminal “PL”. When controlled by switch connect switched live wire to terminal SL and permanent live to PL. Note: if “SL” terminal not connected, fitting works as non-maintained
- Plug in connector, attach diffuser/ LEDs and tighten screws. Ensure that it is secure
Testing
The emergency lighting must be inspected and tested regularly in accordance
with local codes of practice: note: for safety reasons tests should be carried
out during daylight hours.
The minimum recommended test schedule is as follows: After installation, allow
24 hours to ensure full battery charge and then interrupt the supply; the
maximum duration time is 3 hours check that LEDs are still lighting.
- Daily check that charge indicator LED is working
- Monthly, interrupt mains for a short period and check LED lights
- Annual 12 month check, full duration test. Interrupt mains supply, LEDs will light and should last for a minimum 3 hours operation: batteries must be replaced when they can no longer support 3 hour operation.
- Complete record sheet on installation and retain in maintenance file. 5. Update file with ongoing test records for inspection by fire officer or another duly authorised person
Switch on supply: The green LED should come on indicating correct battery
charge status. When supply to permanent live PL is lost, battery will operate
fitting in emergency mode
Market Surveillance: These products contain light sources ‘LS Code’ of energy
efficiency of Class D. RCA244012-LS, RCA484012-LS, RCA484015-LS, RCA804015-LS
Disconnect driver input and output connections.
Remove screws and remove diffuser. Remove LED PCB
Information for the Product user:
- Please note the requirement to dispose of Waste Electrical & Electronic Equipment separately from household waste (WEEE marked with crossed-out wheelie bin symbol).
- Please consider your role in contributing to re-use and recycling by returning this product at end of life to a collection centre for waste electrical equipment or a Civic Amenity site, or to a retail outlet from which you are purchasing a replacement.
- This equipment may contain substances that are hazardous to health and the environment if disposed of carelessly. It is important that it is separated from normal household waste and recycled in the WEEE chain
- The “crossed out wheelie bin symbol” on a product indicates this equipment must not be disposed of in normal household
waste, but should be disposed of according to local WEEE regulations
The Installation must be carried out by a qualified electrician
Installation and Maintenance Record:
Installer__
Installation
Type__
Installation test duration & Date_____
Installatie en onderhoud Record:
Installer__
Installation
Type__
Installation test duration & Date_____
Month/Maand
| Tes| 1st Year/ 1st Jaar| 2st Year/2st Jaar| 3st Year/3st Jaar| 4st Year/4st
Jaar| 5st Year/ 5st Jaar
---|---|---|---|---|---|---
Signed/Tekende| Date| Signed/Tekende| Date| Signed/Tekende| Date|
Signed/Tekende| Date| Signed/Tekende|
Date
1
| Short| | | | | | | | | |
2
|
Short
| | | | | | | | | |
3|
Short
| | | | | | | | | |
4
|
Short
| | | | | | | | | |
5
|
Short
| | | | | | | | | |
6
|
Short
| | | | | | | | | |
7
|
Short
| | | | | | | | | |
8
|
Short
| | | | | | | | | |
9
|
Short
| | | | | | | | | |
10
|
Short
| | | | | | | | | |
11
|
Short
| | | | | | | | | |
12
| Short| | | | | | | | | |
3Hr.
| | | | | | | | | |
Tel: +353 1 7099000
Fax: +353 1 7099060
Email: info@robus.com
Website: www.robus.com
L.E.D lighting & Electrical Distribution Group UC
IRE: Nangor Road, Dublin 12, D12 E7VP, Ireland
UK: Bracknell Enterprise & Innovation Hub, Ocean
House, 12th Floor, The Ring, Bracknell,
Berkshire RG12 1AX, UK
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>