SUPER BRIGHT LEDS VTSxD Series Vapor Tight LED Light Fixture User Manual
- June 6, 2024
- super bright leds
Table of Contents
SUPER BRIGHT LEDS VTSxD Series Vapor Tight LED Light Fixture
Included Parts
- 1 – Vapor Tight LED Light Fixture (VTS2D-xKx or VTS4D-xKx)
- 2 – Mounting Brackets
- 2 – Drywall Anchors
- 2 – M4x 30mm long anchor screws
- 2 – M4 Flat washers
- 2 – Liquid Tight Cord Grip (one loose and one preinstalled in fixture)
Optional Recommended Parts
Available at superbrightleds.com
- Power Cord (_POWERCORD)
- Suspension Kit (VTLM-HKO)
- SJT Cable – Black Jacketed 18 Gauge (WP18-35J)
- 22-12 AWG Orange/Blue 3M Wire Nut (WN-OB2212)
- Motion Sensor Kit (VTS-SENSORKIT)
Note: Requires additional wiring [not included]
Safety and Notes
- This product should be installed by a certified electrician in accordance with applicable national, state, and local building and electrical codes.
- To reduce the risk of electric shock, ensure that the main power source and circuit breakers are switched off before performing any installation or wiring procedures.
- Avoid looking directly into the lamp when illuminated.
- Ensure all mounts are securely attached and will support the weight of the fixture. Failure to properly support the fixture may result in damage or injury, for which the manufacturer does not assume responsibility.
Daisy Chain Installation
Motion Sensor Installation
Identify the sensor mounting holes on the reflector board.
Install mounting hardware, controller, and sensor onto the board using provided hardware. Standoffs can be attached to controller first for easier installation.
FINAL ASSEMBLY
Wire with included instructions (VTS-SENSORKIT). Wire fixture in accordance
with national, state, local and electrical codes.
Dimensional Diagram
Surface Mount Installation
Suspension Installation
Suspension Kit (VTLM-HKO) sold separately at superbrightleds.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>