HOOKE ROAD 2024 JLU 4-Door JL Running Boards 4 Doors Side Step Bars Installation Guide
- June 1, 2024
- HOOKE ROAD
Table of Contents
HOOKE ROAD 2024 JLU 4-Door JL Running Boards 4 Doors Side Step Bars
Specifications
- Model: BXG.3059-S
- Qty: 4 Hex Bolts, 24 Button Head Socket Cap Bolts Screws M820, 28 Split Lock Washer D8, 28 Flat Washer M820*2, 24 Flange Hex Lock Nuts M8
- Tools Required: Drive Socket Ratchet Wrench, 13mm Deep Socket, 5mm Hex Bit Socket
- Installation Time: About 40 minutes, 1-2 people may be needed
Product Usage Instructions
Step-by-Step Installation Guide:
- Passenger Side Installation:
- Remove the factory vehicle side step.
- Assemble the mounting bracket with the Button Head Socket Cap Bolts Screws groups. Do not tighten these bolts yet.
- Lift the side step into position, ensuring correct mounting locations.
- Install the Button Head Socket Cap Bolts Screws groups without tightening. Then, use the Hex Bolts, Split Lock Washer, and Flat Washer in inside holes. Adjust the side step position and tighten all bolts.
- Repeat the same installation method on the driver’s side.
- Adjust the main body left and right to a comfortable position.
- Installation is complete. Enjoy your off-road adventures with this quality Hooke Road product!
PARTS
MAKE A DIFFERENCE
HARDWARE
Tools required
- a. Drive Socket Ratchet Wrench;
- b. 13mm Deep Socket;
- c. 5mm Hex Bit Socket
Installation time
About 40 minutes, 1-2 people may be needed. Installation time may differ
according to your mechanical skill level. (PLEASE VERIFY ALL PARTS ARE PRESENT
AND READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION!)
To view the electronic version (BXG.3059-S), please scan the QR code.
Installation instruction
Passenger Side Installation
-
Step 1: Remove the factory vehicle side step and be ready to install our sidestep. Distinguish the Mounting Brackets (According to the number).
Note: The mounting bracket “13” is both for the rear. Mounting bracket”9″ is the driver’s side for the front, and mounting bracket “11” is the passenger side front.
-
Step 2: Assemble the mounting bracket with the (M8*20) Button Head Socket Cap Bolts Screws groups. Don’t tighten up those bolts.
-
Step 3: Lift up the side step into the position. Make sure that mounting locations are correct.
-
Step 4 : Install the (M820) Button Head Socket Cap Bolts Screws groups. Don’t tighten up those bolts. Then, use the (M820) Hex Bolts, (D8) Split Lock Washer, (M8202) Flat Washer in inside holes. Adjust the side step position and tighten up all bolts
-
Step 5 : Repeat the same installation method in the driver side.
-
Step 6: Adjust the main body left and right to the comfortable position.
-
Step 7 : The installation is complete. We hope you enjoy a wonderful off-road life with this quality Hooke Road product!
Attention
- The product parts in this instruction may differ slightly from the actual product contents but generally do not affect the installation of the product.
- Please feel free to contact your distributor if you have any kind of questions about your purchase.
FAQ
- Will the product parts in the instructions differ from the actual product contents?
- The product parts mentioned in the instructions may vary slightly from the actual contents but generally do not affect the installation process.
- Who should I contact if I have questions about my purchase?
- Please feel free to contact your distributor if you have any questions regarding your purchase.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>