SloanLED 100L1 24 VDC Power Supply Installation Guide
- June 6, 2024
- SloanLED
Table of Contents
100L1 24 VDC Power Supply
Installation Guide
|
---|---
1. Tools required: Wire strippers, drill, and screwdriver.| 2. Supplies
required: Conduit and electrical enclosure for power supply (if not placed in
a sign made from enclosure rated material), #8 pan head screws, UL Listed PLTC
cable, UL Listed electrical wire connectors (e.g., wire nuts), silicone.
Europe: Electrical enclosure for power supply, M4 pan head screws, PLTC cable,
silicone, 3M™ Scotchlok™ connectors.
|
3. Power Supply: Identify primary wires, secondary wires, and the location of
mounting tabs.| 4. Mount Power Supplies: Use mounting tab in the corner to
secure power supply.
5. Connect Primary: CAUTION: Have a licensed electrician connect to the
primary.
NOTE: Ensure adequate ventilation. Power supply operating ambient
temperature is -40º to 55º C. Power supply must be mounted in an enclosure
(i.e., the transformer can/raceway). Power supply spacing to thermoplastic,
wood, fiber, or other combustible type enclosure materials shall be 1″ (25
mm). Two or more adjacent power supplies shall not be mounted closer than 1″
(25 mm) end to end or 4″ (102 mm) side to side.
If mounted inside a sign cabinet, UL requires that the cabinet is made from an
enclosure-rated material. Ensure power supplies are not overloaded by
verifying output current is less than 4.15 DC Amps. It is recommended to use
photocells or light sensors to prolong the life of the power supply and to
keep unit at maximum operating efficiency.
TROUBLESHOOTING
If the sign is not functioning properly, check the following:
- Primary voltage is between 120-277 VAC
- Secondary voltage is 24 VDC
- Output current is 4.15 Amps or less
- The power supply is not overloaded (see power supply capacity chart in product installation guide or SloanLED.com)
- There are no shorts in the secondary wiring
- All secondary connections are RED-TO-RED and BLACK-TO-BLACK
SloanLED products carry a limited warranty.
For complete details refer to the warranty policy found at
SloanLED.com Some or all of the products shown are
covered by U.S. and foreign patents pending and covered by one of more of the
following U.S. patents issued:
6776504, 6969179, 7192157, 6932495, 7241031
Customer service and technical support
SloanLED Headquarters
5725 Olivas Park Drive, Ventura, CA, USA
888.747.4LED (888.747.4533) • info@SloanLED.com
SloanLED.com
P/N 402794 Rev A 2021-03-24
SloanLED Europe b.v.
Argonstraat 110, 2718 SN Zoetermeer, NL
+31 88 12 44 900 • Europe@SloanLED.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>