VHS-6720-X-BBZ-R1 Low Voltage Landscape Lighting Instruction Manual

: June 9, 2024
: VOLT

Table of Contents

INSTALLATION INSTRUCTIONS
- Important: Please Read Before Installation
- Important Safety Instructions
Package Content
Product Dimensions
Product Dimensions
Read User Manual Online (PDF format)
Download This Manual (PDF format)

VHS-6720-X-BBZ-R1 Low Voltage Landscape Lighting

INSTALLATION INSTRUCTIONS

Important: Please Read Before Installation

This fixture is intended for installation in accordance with local codes and the National Electric Code (NEC). Failure to adhere to these codes and instructions may result in serious injury, property damage and void the warranty.

These instructions do not intend to cover all variations in installation, operation maintenance or mounting situations.

Make sure that the power is turned OFF before installing or servicing this fixture.
Warning: this fixture is not intended to be installed within 10 feet [3 meters] of a pool, spa or fountain.
This fixture is intended to be used only with a power supply (transformer) rated maximum of 300 watts (25 AMPS) at 15 volts.
Underground Low Energy Cable must not be buried over 6” (15.2 cm) in order to connect to the main low voltage cable.
Wiring connections must be made with UL listed wire connectors that are suitable for outdoor use.
Position the wire connector so that it is located within 6 inches (15.2 cm) from a building structure, a luminaire, or fitting.

Important Safety Instructions

LIGHTED LAMP IS HOT!

WARNING – TO REDUCE THE RISK OF FIRE OR INJURY TO PERSONS.

Turn off/unplug and allow to cool before reducing lamp.
Lamp gets HOT quickly!
Do not touch the hot lens, guard or cowl.
Keep lamp away from materials that may burn.
Do not touch lamp at any time.
Use a soft cloth.
Oil from skin may damage lamp.
Do not operate the fixture with a damaged or missing lens or shield.

Package Content

A. (1) Fixture Body

Product Dimensions

Remove Lens

Remove the lens from the luminaire by loosening the lock screws.
Install Lamp

Insert lamp with the correct wattage and type marked on the fixture label and push firmly into place.
CAUTION: Do not exceed maximum wattage marked on luminaire label.
Install Lens

Install the lens back onto the luminaire and tighten with previously removed lock screws.
Install Fixture to Mounting Surface

Place the fixture body onto the desired location. Mark four points on the mounting surface using the holes of the mount as a guide. Set the fixture aside and drill the proper holes where you placed the marks then insert the wall anchors into the drilled holes. Place the fixture onto the surface and secure with screws using a screwdriver.
Wire Connection

Strip both leads from the luminaire pigtail. Using two wire connectors (sold separately), connect the leads from the luminaire to the main supply cable leads.
Adjust Luminaire Direction

Using an Allen Key, loosen the set screws on the side of the fixture to rotate the luminaire to your desired direction by hand. Once you have the desired angle, tighten down the set screws with the Allen Key.