SloanLED 60C3D 12 VDC Power Supply Installation Guide
- June 5, 2024
- SloanLED
Table of Contents
SloanLED 60C3D 12 VDC Power Supply
-
Tools required: Wire strippers, drill, and screwdriver.
-
Supplies required: Conduit and electrical enclosure for power supply (if not placed in a sign made from enclosure rated material), #8 pan head screws, UL Listed PLTC cable, UL Listed electrical wire connectors (e.g., wire nuts), silicone.
Europe: Electrical enclosure for power supply, M4 pan head screws, PLTC cable, silicone, 3MTM Scotch lock TM connectors. Mounting Tabs Primary Wires (Brown & Blue)
-
Power Supply: Identify primary wires, secondary wires, and location of mounting tabs.
-
Mount Power Supplies: Use mounting tab in corner to secure power supply.
-
Connect Primary:
CAUTION: Have a licensed electrician connect primary.
NOTE: Ensure adequate ventilation. Power supply operating ambient
temperature is -40º to 60º C. Power supply must be mounted in an enclosure
(i.e., transformer can/raceway). Power supply spacing to thermoplastic, wood,
fiber, or other combustible type enclosure materials shall be 1″ (25 mm) Two
or more adjacent power supplies shall not be mounted closer than 1″ (25 mm)
end to end or 4″ (102 mm) side to side. If mounted inside a sign cabinet, UL
requires that cabinet is made from an enclosure rated material. Ensure power
supplies are not overloaded by verifying output current is less than 5 DC
Amps. It is recommended to use photocells or light sensors to prolong life of
power supply and to keep unit at maximum operating efficiency.
TROUBLESHOOTING
If sign is not functioning properly, check the following:
- Primary voltage is between 120-277 VAC
- Secondary voltage is 12 VDC
- Output current is 5 Amps or less
- Power supply is not overloaded (see power supply capacity chart in product installation guide or SloanLED.com)
- There are no shorts in secondary wiring
- All secondary connections are RED-TO-RED and BLACK-TO-BLACK
Dimming by voltage
Dimming voltage (V)
Dimming by PWM
Some or all of the products shown are covered by U.S. and foreign patents pending and covered by one of more of the following U.S. patents issued: 6776504, 6969179, 7192157, 6932495, 7241031
Customer service and technical support
SloanLED Headquarters 5725 Olivas Park Drive, Ventura, CA, USA 888.747.4LED
(888.747.4533)
SloanLED Europe b.v.
Argonstraat 110, 2718 SN Zoetermeer, NL
+31 88 12 44 900