SloanLED P-N 403150-SB Street Wrap Flex Side-Bend Installation Guide
- June 1, 2024
- SloanLED
Table of Contents
SloanLED P-N 403150-SB Street Wrap Flex Side-Bend
Product Information
Specifications
- Product Name: Street WrapTM Flex Side-Bend
- Model Number: P/N 403150-SB
- Material: Aluminum extrusion
- Includes: Finish clips, Mounting clips, Mounting accessories, Steel chain for curve installations
Product Usage Instructions
Cutting and Sealing
- Cut on the designated cut mark using a pipe cutter.
- Clean the cut end before proceeding to the next steps.
- Install the silicone insert after cutting.
- Coat the end cap with silicone glue and install it.
Installation
- Drill screw holes as needed and install mounting accessories with provided screws.
- Gently press the product into the mounting accessories.
Additional Instructions
- Do not twist or bend the product abruptly or severely to avoid cracking copper trace or solder connections.
- Handle products longer than 6.6 ft (2 m) with a minimum of two employees.
- Avoid twisting or pulling the product by the cable.
FAQs
-
Q: Can I twist or bend the product at sharp angles?
A: No, twisting or bending the product at sharp angles can result in cracking of copper trace or solder connections, which may lead to section outages and void your warranty. -
Q: Are there pre-drilled holes in the aluminum extrusion?
A: No, there are no pre-drilled holes in the aluminum extrusion. You need to drill holes accordingly to meet field requirements using appropriate screws.
Street Wrap™ Flex Side-Bend
Installation Guide
Cutting and Sealing
Installation tools & components
- Cut on designated cut mark.
- Clean cut end before next steps.
- Install silicone insert after cut.
- Coat end cap with silicone glue and install.
CAUTION
Do NOT twist and bend this product abruptly or severely.
This action may cause copper trace or solder connections to crack, resulting
in section outages along the strand.
TAKE EXTREME CAUTION WHEN UNBOXING AND INSTALLING.
- Outages caused by these actions may void your warranty.
- Unwind Flex strip from coil or reel carefully and without twisting.
Installation
NOTE: There are no pre-drilled holes in the aluminum extrusion, please drill holes accordingly to meet field requirements, using the appropriate screw.
- Mounting Accessories
1. Drill screw hole and install mounting accessories with screws provided.
2. Gently press product into mounting accessories.
Warnings
Customer service and technical support
SloanLED Headquarters
3490 Venture Dr., San Angelo, TX, USA 325 227 4577 •
info@SloanLED.com
SloanLED.com
P/N 403150-SB Rev A 2024-02-15
SloanLED Europe b.v.
Argonstraat 110, 2718 SN Zoetermeer, NL
+31 88 12 44 900 • Europe@SloanLED.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>