Gasolarxy PG-KITS200W-18VS 200 W Foldable Solar Panel Installation Guide

Gasolarxy PG-KITS200W-18VS 200 W Foldable Solar Panel

Delivery Content

• Module No Solar Panel
• Cable Manual

Explanation of symbols

The lightning symbol inside a triangle is used when there is a potential risk of personal injury, such as electric shock. An exclamation mark in a triangle indicates important instructions in this operating manual that absolutely have to be observed.

How to use

1. Unfold the folding solar charger and open the bracket to adjust the angle to let the front of the solar panel is completely facing the sun.
2. Select the suitable output interface according to your needs.

Safety instructions

Read the operating instructions carefully and especially observe the safety information. If you do not follow the safety instructions and information on proper handling in this manual, we assume no liability for any resulting personal injury or damage to property. Such cases will invalidate the warranty/guarantee.

Attention and cleaning

Regularly clean the solar module, as its performance would otherwise decrease and the surface could be irreversibly damaged.

• Please read the user guide before using this product.
• The solar panel will generate voltage when it was exposed in the sun, so please avoid installing the solar system in the sun. If it must be installed in the sun, insulation protection is required.
• Before assembling, pay attention to the positive and negative signs, the positive and negative poles cannot be reversed.
• Do not step on, or disassemble the solar panel.
• Do not place the solar panel in shading places such as trees and buildings.
• Do not soak the solar panel in water or any other liquid.
• Do not use or store solar panels near open flames or flammable materials.
• Do not scratch the solar panel with sharp objects.
• Do not put corrosive substances on the solar panel.
• Charge device to check whether the solar panel is working.

Specification

Model| Maximum power| Maximum Power Voltage| Maximum Power Current| Open Circuit Voltage| Short Circuit current| IP Level| Unfolded Size| Folded Size| Operating temperature| Weight
---|---|---|---|---|---|---|---|---|---|---
PG-KITS200W-18 VS| 200 W| 18 V| 11.11 A| 21.6 V| 12.22 A| IP64| 231066520 mm| 66561440 mm| -20-65| 8 kg

Disposal

End users are responsible for deleting personal data from the WEEE to be disposed of. It should be noted that different obligations about the return or recycling of WEEE may apply in countries outside of Germany. Distributed by Conrad Electronic SE, Klaus-Conrad-Str. 1 D-99240 Hirschau

To use the 200 W Foldable Solar Panel, follow these instructions:

1. Unfold the solar charger and open the bracket to adjust the angle so that the front of the solar panel is facing the sun.
2. Select the appropriate output interface based on your needs.
3. Read the safety instructions carefully and follow them to avoid personal injury or damage to property.
4. Regularly clean the solar module to ensure optimal performance and avoid irreparable damage.
5. Do not install the solar panel in direct sunlight unless insulation protection is used.
6. Before assembly, make sure to pay attention to the positive and negative signs and ensure that the positive and negative poles are not reversed.
7. Do not step on or disassemble the solar panel, and avoid placing it in shaded areas, soaking it in liquids, using or storing it near open flames or flammable materials, scratching it with sharp objects, or putting corrosive substances on it.
8. To check whether the solar panel is working, charge a device using it.

Delivery Content

Explanation of symbols

The lightning symbol inside a triangle is used when there is a potential risk of personal injury, such as electric shock. An exclamation mark in a triangle indicates important instructions in this operating manual that absolutely have to be observed.

How to use

1. Unfold the folding solar charger and open the bracket to adjust the angle to let the front of the solar panel is completely facing the sun.
2. Select the suitable output interface according to your needs.

Safety instructions

Read the operating instructions carefully and especially observe the safety information. If you do not follow the safety instructions and information on proper handling in this manual, we assume no liability for any resulting personal injury or damage to property. Such cases will invalidate the
warranty/guarantee.

• The device is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. This may become dangerous playing material for children.
• Protect the product from extreme temperatures, strong jolts, flammable gases, vapours and solvents.
• Do not place the product under any mechanical stress.
• If it is no longer possible to operate the product safely, take it out of operation and protect it from any accidental use. Safe operation can no longer be guaranteed if the product:
  • is visibly damaged,
  • is no longer working properly,
  • has been stored for extended periods in poor ambient conditions or
  • has been subjected to any serious transport-related stresses.
• Please handle the product carefully. Jolts, impacts or a fall even from a low height can damage the product.
• Also observe the safety and operating instructions of any other devices which are connected to the product.
• The solar module performance can vary depending on weather conditions. Keep this in mind when operating a device with this product.
• Do not touch the terminal points during operation.
• Use suitable extension cables and adaptor plugs approved for outside operation . Do not use bare wires or other uninsulated objects to connect the product.
• Always ensure correct polarity when connecting a device.
• Avoid direct contact with the surface. The surface is sensitive and can be easily scratched or destroyed through contamination. solar module may only be used in a temperate climate. The solar module is a device which is not secured against explosions. Thus, it may not be installed in the vicinity of highly inflammable gases and vapours.
• If this solar module is used in a system consisting of multiply solar modules, all modules used must have the same amperage. Only solar modules with identical amperage may be used when connected in series. Only solar modules with identical voltage may be used when connected in parallel.
• Consult an expert when in doubt about operation, safety or connection of the device.
• Maintenance, modifications and reparis are to be performed exclusively by an expert.

Attention and cleaning

Regularly clean the solar module, as its performance would otherwise decrease and the surface could be irreversibly damaged.

• Please read the user guide before using this product.
• The solar panel will generate voltage when it was exposed in the sun, so please avoid installing the solar system in the sun. If it must be installed in the sun, insulation protection is required.
• Before assembling, pay attention to the positive and negative signs, the positive and negative poles cannot be reversed.
• Do not step on, or disassemble the solar panel.
• Do not place the solar panel in shading places such as trees and buildings.
• Do not soak the solar panel in water or any other liquid.
• Do not use or store solar panels near open flames or flammable materials.
• Do not scratch the solar panel with sharp objects.
• Do not put corrosive substances on the solar panel.
• When using the solar panel the circuit must be correctly connected to the equipment and check the connection status of each component each wire and plug.
• Due to the material characteristics of the product, it is strictly forbidden to drop it, otherwise, it will cause internal damage to the solar panel and make the product unusable.
• Use a soft brush or damp cloth to clean the dust on the surface of the product If there are bird droppings or other sticky objects on the surface of the product it should be cleaned up immediately.
• What should I do if there is no output from the solar panel?
• Please put the solar panel in a sunny environment and check the connection status of each component, each wire, and plug. You can try to replace the data cable or charge the device to check whether the solar panel is working.

Specification

Disposal
This symbol must appear on any electrical and electronic equipment placed on the EU market. This symbol indicates that this device should not be disposed of as unsorted municipal waste at the end of its service life. Owners of WEEE (Waste from Electrical and Electronic Equipment) shall dispose of it separately from unsorted municipal waste. Spent batteries and accumulators, which are not enclosed by the WEEE, as well as lamps that can be removed from the WEEE in a non-destructive manner, must be removed by end users from the WEEE in a non-destructive manner before it is handed over to a collection point. Distributors of electrical and electronic equipment are legally obliged to provide free take-back of waste. Conrad provides the following return options free of charge (more details on our website):

• in our Conrad offices
• at the Conrad collection points
• at the collection points of public waste management authorities or the collection points set up by manufacturers or distributors within the meaning of the ElektroG

End users are responsible for deleting personal data from the WEEE to be disposed of. It should be noted that different obligations about the return or recycling of WEEE may apply in countries outside of Germany. Distributed by Conrad Electronic SE, Klaus-Conrad-Str. 1 D-99240 Hirschau

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>