SloanLED Flex Mini Street Wrap Installation Guide
- June 1, 2024
- SloanLED
Table of Contents
SloanLED Flex Mini Street Wrap
Specifications
- Product Name: Street WrapTM Flex Mini
- Model Number: P/N 403150-M
- Installation Guide Revision: A
- Release Date: February 15, 2024
- Maximum Length: 6.6 ft (2 m)
Product Usage Instructions
Cutting and Sealing
-
1. Cut on the designated cut mark using a pipe cutter.
CAUTION: Do NOT twist or bend the product abruptly or severely to prevent damage to copper trace or solder connections.
Twisting or bending may cause section outages along the strand, voiding the warranty.
- Clean the cut end before proceeding to the next steps.
- Coat the end cap with silicone glue and install it securely.
Mounting Instructions
Street Wrap Flex Mini can be mounted on any surface suitable for conventional fasteners.
-
1. Place mounting clips as needed to shape the product to the desired contour.
Fasten the clips to the mounting surface using #4 pan head screws or 0.125 (3.18 mm) rivets.
-
1. Gently press the product into the mounted clips.
IMPORTANT: Do not pull or hold the product by the cable, and avoid twisting or bending at sharp angles.
For assemblies longer than 6.6 ft (2 m): Careful handling with a minimum of two employees is required.
FAQ
- Q: Can I twist or bend the Street Wrap Flex Mini abruptly?
- A: No, twisting or bending abruptly can cause damage to the product, resulting in section outages and voiding the warranty.
- Q: How should I handle assemblies longer than 6.6 ft?
- A: For longer assemblies, it is recommended to have a minimum of two employees for careful handling to prevent damage during installation.
Cutting and Sealing
Installation tools
- Cut on designated cut mark.
- Clean cut end before next steps.
- Coat the end cap with silicone glue and install it.
CAUTION
Do NOT twist and bend this product abruptly or severely.
This action may cause copper trace or solder connections to crack, resulting
in section outages along the strand.
TAKE EXTREME CAUTION WHEN UNBOXING AND INSTALLING.
- Outages caused by these actions may void your warranty.
- Unwind the Flex strip from the coil or reel carefully and without twisting.
Installation
- Street Wrap Flex Mini can be mounted to any surface that will accommodate conventional fasteners.
Mounting Accessories
- Place mounting clips wherever necessary to shape Street Wrap Flex Mini to the desired contour. Fasten clips to the mounting surface using #4 pan head screws or 0.125″ (3.18 mm) rivets.
- Gently press the product into mounted clips.
Warnings
TOP VIEW
SIDE VIEW
- For assembly of Street Wrap Flex Mini longer than 6.6 ft (2 m):
- Careful handling with a minimum of two (2) employees is required.
CONTACT
SloanLED Headquarters
- 3490 Venture Dr., San Angelo, TX, USA
- 325 227 4577
- info@SloanLED.com
- SloanLED.com
SloanLED Europe b.v.
- Argonstraat 110, 2718 SN Zoetermeer, NL
- +31 88 12 44 900 • Europe@SloanLED.com.