SloanLED P-N 403150-P Street Wrap Flex Pod Installation Guide
- June 1, 2024
- SloanLED
Table of Contents
SloanLED P-N 403150-P Street Wrap Flex Pod
Product Information
Specifications
- Product Name: Street WrapTM Flex Pod
- Components: Silicone insert, Silicone end cap, Silicone glue, Pipe cutter
- Installation Tools: Pipe cutter, Silicone glue
- Caution: Do NOT twist or bend abruptly, may cause copper trace or solder connections to crack
Product Usage Instructions
Cutting and Sealing
- Cut on designated cut mark.
- Clean cut end before proceeding to the next steps.
- Install silicone insert after the cut.
- Apply silicone glue to the silicone end cap, ensuring the cut section is completely sealed.
Installation
Note: There are no pre-drilled holes in the aluminum extrusion, please drill
holes accordingly to meet field requirements, using the appropriate screw.
- Mounting Accessories: Steel chain for curve installations
- Warnings: Street Wrap Flex Pod only bends as shown above.
- Drill screw hole and install mounting accessories with screws provided.
- Gently press the product into mounting accessories.
FAQ
-
Q: Can I twist or bend the product at sharp angles?
A: No, twisting or bending the product at sharp angles may cause damage to the copper trace or solder connections, leading to section outages along the strand. -
Q: What should I do if I encounter section outages?
A: Outages caused by improper twisting or bending actions may void your warranty. Ensure to follow the cutting and sealing instructions carefully to prevent such issues.
WHAT’S INCLUDE
INSTALLATION
- Cut on designated cut mark.
- Clean cut end before next steps.
- Install silicone insert after cut.
- Apply silicone glue to silicone end cap, making sure that cut section is completely sealed.
CAUTION
Do NOT twist and bend this product abruptly or severely.
This action may cause copper trace or solder connections to crack, resulting
in section outages along the strand.
TAKE EXTREME CAUTION WHEN UNBOXING AND INSTALLING.
Outages caused by these actions may void your warranty. Unwind Flex strip from coil or reel carefully and without twisting.
NOTE: There are no pre-drilled holes in the aluminum extrusion, please drill holes accordingly to meet field requirements, using the appropriate screw.
Warnings
Customer service and technical support
Installation Guide
SloanLED Headquarters
3490 Venture Dr., San Angelo, TX, USA
325 227 4577
[email protected]
SloanLED.com
SloanLED Europe b.v.
Argonstraat 110, 2718 SN Zoetermeer, NL
+31 88 12 44 900
[email protected]