SloanLED P-N 403150-BB Street Wrap Flex Back-Bend Installation Guide
- June 1, 2024
- SloanLED
Table of Contents
SloanLED P-N 403150-BB Street Wrap Flex Back-Bend
Product Information
Specifications:
- Product Name: Street Wrap™ Flex Back-Bend
- Model Number: P/N 403150-BB
- Material: Aluminum extrusion
- Length: Up to 6.6 ft (2 m)
- Components: Mounting clips, Finish clips, Silicone glue, Pipe cutter
Product Usage Instructions
Cutting and Sealing:
- Cut on designated cut mark using a pipe cutter.
- Clean cut end before proceeding to the next steps.
- Install silicone insert after cutting.
- Apply silicone glue to the silicone end cap to completely seal the cut section.
Installation:
- Drill screw holes as needed in the aluminum extrusion to meet field requirements.
- Install mounting accessories with provided screws.
- Gently press the product into the mounting accessories.
Warnings:
- Avoid twisting or bending the product at sharp angles.
- Do not pull or hold the product by the cable.
- For lengths longer than 6.6 ft (2 m), handle with a minimum of two employees.
FAQ:
-
Q: Can I twist or bend the product abruptly?
A: No, twisting or bending the product abruptly may cause copper trace or solder connections to crack, leading to section outages along the strand and potentially voiding the warranty. -
Q: Are there pre-drilled holes in the aluminum extrusion?
A: No, there are no pre-drilled holes in the aluminum extrusion. You need to drill holes according to field requirements for installation.
WHAT’S INCLUDE
INSTALLATION INSTRUCTION
- Cut on designvated cut mark.
- Clean cut end before next steps.
- Install silicone insert after cut.
- Apply silicone glue to silicone end cap, making sure that cut section is completely sealed.
CAUTION
Do NOT twist and bend this product abruptly or severely.
This action may cause copper trace or solder connections to crack, resulting
in section outages along the strand.
TAKE EXTREME CAUTION WHEN UNBOXING AND INSTALLING.
Outages caused by these actions may void your warranty.
Unwind Flex strip from coil or reel carefully and without twisting.
NOTE: There are no pre-drilled holes in the aluminum extrusion, please drill holes accordingly to meet field requirements, using the appropriate screw.
Warnings
Customer service and technical support
Installation Guide
SloanLED Headquarters
3490 Venture Dr., San Angelo, TX, USA
325 227 4577
info@SloanLED.com
SloanLED.com
SloanLED Europe b.v.
Argonstraat 110, 2718 SN Zoetermeer, NL
+31 88 12 44 900
Europe@SloanLED.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>