BRANDSON 303030 Standing Fan User Manual

BRANDSON 303030 Standing Fan

Important safety guidelines for this device

• Use the device for the private and in-tended purpose only. This device is not intended for commercial use. Do not use the device outdoors and keep it away from heat and direct sunlight.
• Please do not keep the device in the immediate vicinity of water sources such as bathtub, shower, washbasin or swimming pool.
• Do not use this device with wet hands.
• If the device becomes moist or wet, pull out the power plug immediately. Maintain your own safety and do not touch any conductive material on the device.
• Protect the device from moisture (this device should not be immersed in liq-uids under any circumstances), sharp edges or large sources of dust.
• Do not keep the device in the immedi-ate vicinity of heat sources (e.g. ovens or heaters)
• Keep it on an appropriate surface so that it does not tip over
• Unplug the power plug when the de-vice is not in use, during transport or during cleaning
• Never leave the fan unattended and choose a location such that the device is out of reach of animals and children
• Operate the device only with the volt-age mentioned on the device label
• This device can be used by children aged from 8 years and above and per-sons with reduced physical, sensory or mental capabilities or lack of ex-perience and knowledge if they have been given supervision or instruction concerning the safe use of the device and understand the hazards involved.
• Children should not play with the de-vice. Cleaning and user maintenance shall not be made by children without supervision.
• Keep the device and its connection ca-ble out of reach of children under 8 years
• For the safety of your children, keep the packaging parts away from their reach (plastic bag, foils, carton or pol-ystyrene).
• Do not allow small children to play with the foil or plastic bags as there is a risk of suffocation!
• While operating the device, ensure that the protective cage is closed
• The fan, rotational switch and switch-es should not be blocked!
• It is not allowed to remove the grille for cleaning purposes once the fan is mounted.
• Never insert your body parts (e.g. fin-gers) or objects through the protec-tive cage
• Ensure that your hair is not within the range of the protective cage as it may get caught in the air current
• If the power cable of this device is damaged, it should be replaced by the manufacturer, his after-sales service or by an equally qualified person, so as to prevent any risk
• Allow the device to cool down before cleaning it, or pull out the power plug from the socket
• Wipe the device housing with a damp-ened cloth and then wipe it with a clean dry cloth. Never immerse the housing in water for cleaning.
• Once the fan is assembled, the pro-tective cage should not be removed
• Thank you for choosing a Brandson product. Please read the following user manual carefully so that you can enjoy your purchased product for a long time.

Scope of supply

• Fan
• User manual

Technical data

(adjustable), rotor blade diameter: 30.2cm

Functions

The Brandson pedestal fan has a powerful motor and 30.2cm rotor blades which ensure optimum ventilation even on hot days. Thanks to the three speed levels, adjustable angle of inclination and oscillation, you can adapt the fan to your indi-vidual requirements.

Product details

Installation

Take the fan out of the package and check the device as well as the scope of deliv-ery mentioned in the table above. Please contact the vendor if any part is missing or has been damaged. Now place the rear protective cage (5) on the fan unit. Make sure that the handle is facing up. Tighten the rear protective cage firmly using the mounting screw (4). Then insert the rotor blade (3) onto the rotor axis (6) and fasten it using the ap-propriate mounting screw (2). In doing so, ensure that the screw sits on the notch of the shaft of the motor axis in order to guarantee a firm grip! Mount the front protective cage (1) onto the rear protective cage. A hole is pro-vided for a locking screw at the bottom of the two protective cages. Insert the locking screw (21) through the hole of the front and rear guards and fas-ten it using the locking nut. Then connect the four mounting brackets to the side. Take the pedestal weight (13), place the pedestal cover (12) on it and connect the outer pipe (20) to the pedestal. Fix the outer pipe (20) to the pedestal (12) from below using the fastening screw (14,15).To connect the inner tube (10) to the motor unit, you must first screw the fixing screw (19) to the inner tube (10). The inner tube is located in the outer tube when delivered and can be pulled out with your fingers. You can then fasten the remain-ing screws (16, 17, 18). Note: If the screws are not in the packaging bag, they are usually pre-assembled at the point where they are to be inserted.

Usage

Keep the fan in an appropriate location and connect the device to a properly installed 220-240V AC socket. By loosening the tilt setting (16) and then tipping the protective cage, you can change the angle of inclination according to your needs. Then tighten the tilt setting at the desired position. Push the pin at the top to enable the oscillation. If you do not want to use the oscillation function, pull the pin out slightly. You can select between three different speed levels using the rotary switch on the motor unit.

Speed level|
---|---
0| Off
1| Slow
2| Medium
3| Fast

Cleaning

Pull out the power plug from the socket before starting with the cleaning process! Use a slightly moist cloth for cleaning (wetted with water). For cleaning, never immerse the device into water! This could lead to electric shock or fire!

Safety instructions and liability disclaimer

Never try to open the device to carry out repairs or conversions. Avoid contact with mains voltages. Do not short-circuit the product. The device is not certified for use in the open air; only use it in dry conditions. Protect it from high humidity, water and snow. Keep it away from high temperatures. Do not subject the device to sud-den changes in temperature or heavy vibration as this might damage electronic components. Examine the device for damage before using it.
The unit should not be used if it has received an impact or has been damaged in any other way. Please observe national regulations and restrictions. Do not use the device for purposes other than those described in the instructions. This product is not a toy. Keep it out of the reach of children or mentally impaired persons. Any repair or alteration to the device not carried out by the original supplier, will invalidate the warranty or guarantee. The product may only be used by persons who have read and understood these instructions. The device specifications may change without any separate prior notice to this effect.

Disposal instructions

Electrical and electronic devices may only be disposed of in accordance with the European WEEE Directive and not with household rubbish. Components must be disposed of or recycled separately as dangerous, toxic elements can inflict sustained damage on the environment if they are disposed of incorrectly. As a consumer, you are bound by the Electrical and Electronic Devices Act (ElektroG) to return electrical and electronic goods free of charge at the end of their useful life to the manufacturer, the place of purchase or to specially set up, public collection points. The details in each case are governed by national law. The symbol on the product, the operating instructions, and/or the packaging refers to these regulations. By separating materials in this way, recycling and disposing of old devices, you are making an important contribution towards protecting our environment.

References

• WD Plus - WD Plus
• WD Plus - WD Plus

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>