BRANDSON 301801 Radiant Heater User Manual

BRANDSON 301801 Radiant Heater

Important safety guidelines for this device

• Use the device for private and intended purposes only. This device is not intended for commercial use. Keep it away from heat and direct sunlight.
• Please do not keep the device in the immediate vicinity of water sources such as bathtubs, showers, washbasins or swimming pools.
• Do not use this device with wet hands.
• If the device becomes moist or wet, pull out the power plug immediately. Maintain your own safety and do not touch any conductive material on the device.
• Protect the device from moisture (under no circumstances should the device be immersed in liquid), sharp edges or large sources of dust.
• Do not keep the device in the immediate vicinity of heat sources (e.g. ovens or heating systems).
• Keep it on an appropriate surface so that it does not tip over.
• Unplug the power plug when the de-vice is not in use, during transport, or during cleaning.
• Never leave the heater unattended and choose a location in which the device is safe from the reach of animals and children.
• Operate the device only with the voltage mentioned on the device label.
• This device can be used by children aged 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the safe use of the device and understand the hazards involved.
• Children shall not play with the device. Cleaning and user maintenance should not be carried out by children or untrained personnel.
• Keep the device and its connection cable out of reach of children under 8 years.
• For the safety of your children, keep the packaging parts away from their reach (plastic bag, foils, cartons or polystyrene).
• Do not allow small children to play with the foil or plastic bags as there is a risk of suffocation!
• While operating the device, ensure that the protective cage is closed.
• Never remove the cage for cleaning.
• Never insert your body parts (e.g. fingers) or objects through the protective grille.
• Ensure that your hair is not within the range of the protective cage as it may be signed by the heat.
• If the power cable of this device is damaged, it should be replaced by the manufacturer, his after-sales service or by an equally qualified person, so as to prevent any risk.
• Allow the device to cool down before cleaning it, or pull the power plug out of the socket.
• Wipe the device housing with a damp cloth and dry it subsequently with a clean dry cloth. Never immerse the housing in water for cleaning.
• Once the heater is assembled, the protective cage should not be removed.
• This device is not equipped with any mechanism to control the room temperature.
• Do not use this unit in small rooms if the rooms are occupied by persons who cannot leave the room independently. Unless they are constantly monitored.
• Children between the age of 3 and 8 should be allowed to switch the device on /off only if it has been set up or installed in its intended operating position if care has been taken to supervise or instruct concerning the safe use of the device and the associated risks have been understood. Children between the age of 3 and 8 years should not be allowed to connect the device to the power supply, to make any settings, clean or repair the device.
• The device should be securely placed on a horizontal level surface.
• CAUTION – Some parts of the product may become very hot and cause burns. Be very careful if children or frail persons are present.

Thank you for choosing a Brandson product. Please read the following user manual carefully to have an enjoyable experience with your purchased product.

Scope of delivery

• Radiant heater
• Pedestal
• Remote control
• Mounting accessories
• User manual

Technical data

Power input

| •  Level 1: up to 600W

•  Level 2: up to 1200W

•  Level 3: up to 1800W

Height| 120-190cm
Ambient temperature| 0-40°C
Number of heating elements| 3
Features| •  Adjustable height

•  including remote control

•  3 heating levels

•  Tilt protection

Functions

The Brandson heater ensures focussed radiation of heat with three independently controllable heating elements. With three different heating levels and adjustable inclination angle, you can adjust the heater to your individual requirements.

Product details

Pedestal assembly

Take the heater out of the package and check the device as well as the scope of delivery mentioned in the table above. Please contact the vendor if any part is missing or damaged.
As shown in Figure (A), insert the lower tube (8) through the hole in the pedestal cover (9) and the pedestal (10). Ensure that the welded end is below and guide the extra flap into the shoulder of the pedestal. Fix the tube by screwing the L-screw (12) through the washer (11) into the lower end of the tube.
Then fix the middle tube (7) to the top of the lower tube (8). Now pull the straight tube (3) out from the top. Turn the mounting ring (4) in clockwise direction to press it together. Then fix the upper tube (5) to the middle tube (7).
As shown in Figure (A), slide the straight tube (3) into the hole of the control unit (1). Secure it using a M6*12 screw (2).
Turn the mounting ring (4) as shown in Figure (A) in the counter-clockwise direction to loosen it and to position the heating element at the desired height.
Figure (A) also shows how to attach the power cable to the cable clip (13).
The inclination angle of the heater is up to 25°. Simply adjust it to the desired position. This is shown in Figure (C).

Wall assembly

Drill four holes in the desired place for the wall bracket. Ensure that there are no gas, water or electricity lines running through the wall. Fix the bracket (4) to the holes. Then, install the wall bracket (2) with the corresponding self-tapping screws (3).
Connect the wall bracket to the heating element (C) and fix the two elements using the thumbscrew (5).

Usage

Keep the heater at an appropriate location and connect the device to a properly installed 220-240V AC socket. By tipping the protective cage, you can change the angle of inclination according to your needs.
Flip the switch (14) on the back of the control unit to “1” to activate the device. The heating process is not yet complete! The device is initially in input mode.
By pressing the ON button on the remote control or the control panel, you can turn on the first level. By pressing the “MODE” button, you can increase the level, or reduce the level from the highest to the lowest. If you press the OFF button on the remote control, the device is not switched off completely. It goes to a power-saving standby mode and can be activated again at any time. Due to the tilt protection, it switches itself off.

Cleaning

Pull out the power plug from the socket before starting with the cleaning process. Use a slightly damp cloth for cleaning. The device should not be immersed in wa-ter for cleaning under any circumstances. This could lead to electric shock or fire!

Safety instructions and liability disclaimer

Never try to open the device to carry out repairs or conversions. Avoid contact with mains voltages. Do not short-circuit the product. The device is not certified for use in the open air; only use it in dry conditions. Protect it from high humidity, water and snow. Keep it away from high temperatures. Do not subject the device to sudden changes in temperature or heavy vibration as this might damage electronic components. Examine the device for damage before using it. The unit should not be used if it has received an impact or has been damaged in any other way. Please observe national regulations and restrictions. Do not use the device for purposes other than those described in the instructions. This product is not a toy. Keep it out of the reach of children or mentally impaired persons. Any repair or alteration to the device not carried out by the original supplier will invalidate the warranty or guarantee. The product may only be used by persons who have read and understood these instructions. The device specifications may change without any separate prior notice to this effect.

Disposal instructions

Electrical and electronic devices may only be disposed of in accordance with the European WEEE Directive and not with household rubbish. Components must be disposed of or recycled separately as dangerous, toxic elements can inflict sustained damage on the environment if they are disposed of incorrectly. As a consumer, you are bound by the Electrical and Electronic Devices Act (ElektroG) to return electrical and electronic goods free of charge at the end of their useful life to the manufacturer, the place of purchase or to specially set up, public collection points. The details in each case are governed by national law. The symbol on the product, the operating instructions, and/or the packaging refers to these regulations. By separating materials in this way, recycling and disposing of old devices, you are making an important contribution towards protecting our environmen10 Safety instructions and liability disclaimer
Never try to open the device to carry out repairs or conversions. Avoid contact with mains voltages. Do not short-circuit the product. The device is not certified for use in the open air; only use it in dry conditions. Protect it from high humidity, water, and snow. Keep it away from high temperatures. Do not subject the device to sudden changes in temperature or heavy vibration as this might damage electronic components. Examine the device for damage before using it. The unit should not be used if it has received an impact or has been damaged in any other way. Please observe national regulations and restrictions. Do not use the device for purposes other than those described in the instructions. This product is not a toy. Keep it out of the reach of children or mentally impaired persons. Any repair or alteration to the device not carried out by the original supplier will invalidate the warranty or guarantee. The product may only be used by persons who have read and understood these instructions. The device specifications may change without any separate prior notice to this effect.

The symbol of the rubbish bin with a cross-through it indicates that the battery may not be put in household waste.

• WEEE guideline: 2012/19/EU
• WEEE register number: DE 67896761

WD Plus GmbH, herewith declares that this product 301801 conforms to the principle requirements and other relevant stipulations. The complete Declaration of Conformity can be obtained from WD Plus GmbH, Wohlenbergstraße 16, 30719 Hanover

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>