SloanLED 24/150 Power Supply Installation Guide
- June 6, 2024
- SloanLED
Table of Contents
24/150 Power Supply
Installation Guide
-
Tools required: Wire strippers, drill, and screwdriver.
-
Supplies required: Electrical enclosure for power supply, M4 pan head screws, PLTC cable, silicone, 3M ™ Scotchlok ™ connectors.
-
Power Supply: Identify primary wires, secondary wires, and the location of mounting tabs.
-
Mount Power Supplies: Use the mounting tab in the corner to secure the power supply.
-
Connect Primary: CAUTION: Have a licensed electrician connect to the primary.
NOTE: Ensure adequate ventilation. Power supply operating ambient temperature is -40ºto 60º C. Power supply may be mounted in an enclosure (i.e., the transformer an/raceway). Power supply spacing to thermoplastic, wood, fiber, or other combustible type enclosure materials shall be 25 mm. Two or more adjacent power supplies shall not be mounted closer than 25 mm end to end or 102 mm side to side. Ensure power supplies are not overloaded by verifying output current is less than 6.25 DC Amps (each output). It is recommended to use photocells or light sensors to prolong the life of the power supply and to keep the unit at maximum operating efficiency.
Quantum 24/150 Power Supply
Installation Guide for PN 701895-150E1
TROUBLESHOOTING
If the sign is not functioning properly, check the following:
- Primary voltage is between 200-240 VAC
- Each secondary voltage is 24 VDC
- Each output current is 6.25 Amps or less
- The power supply is not overloaded (see power supply capacity chart in product installation guide or SloanLED.com)
- There are no shorts in the secondary wiring
- All secondary connections are RED-TO-RED and BLACK-TO-BLACK
SloanLED products carry a limited warranty.
For complete details refer to the warranty policy found at
SloanLED.com
Some or all of the products shown are covered by the U.S. and foreign patents pending and covered by one of more of the following U.S. patents issued: 6776504, 6969179, 7192157, 6932495, 7241031
Customer service and technical support
SloanLED Headquarters
5725 Olivas Park Drive, Ventura, CA, USA
888.747.4LED (888.747.4533) • info@SloanLED.com
SloanLED.com
P/N 402730 Rev A 2021-03-02
SloanLED Europe b.v.
Argonstraat 110, 2718 SN Zoetermeer, NL
+31 88 12 44 900 • Europe@SloanLED.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>