FORTIN RFK942 EVO-ONE All-In-One Data Interface Remote Starter/Alarm Installation Guide
- June 6, 2024
- FORTIN
Table of Contents
FORTIN RFK942 EVO-ONE All-In-One Data Interface Remote Starter/Alarm
WIRING / CONNECTION GUIDE
PROGRAMMING REMOTE TRANSMITTER(S)
The system can learn up to a maximum of 4 transmitters. Any transmitters can
be stored in more than 1 memory slot. When a 5th transmitter is learned the
1st remote is erased (FIFO).
ERASES ALL REMOTES THAT HAVE BEEN PROGRAMMED AND RESETS ALL FUNCTIONS BACK TO DEFAULT.
FUNCTION PROGRAMMING
| FUNCTION| MODE 1| MODE 2| MODE 3| MODE 4| MODE 5| MODE 6|
---|---|---|---|---|---|---|---|---
11
| Sound Confirmation & LED antenna Antidémarreur| 1st LOCK/UNLOCK silent 2nd LOCK/UNLOCK sound
—————————
Antenna LED active.
|
LOCK/UNLOCK
sound always.
|
Antenna LED disabled.
|
Antenna LED disabled with ignition.
|
Confirmation sound at LOCK only
|
Panic mode disabled
|
12| Output horn/siren configuration| Horn(-) only.| Siren(+) Output (E1)
white| Siren(+) Output (E1) white and Horn(-)| Siren(-) only (A7)| —| —|
13| Confirmation Pulse| Long| Short| —| —| —| —|
14| Alarm ON/OFF Starter ON/OFF| Alarm OFF Remote-starter ON| Alarm ON Remote-
starter ON.| Alarm ON Remote-starter OFF| —| —| —|
15
|
Smart Arming Smart Doorlock Smart Lock pulse
|
Disable
| (Unlock signal) Automatically LOCK and rearm alarm if door(s) are not opened after 30 seconds.|
Automatic Lock when starter kill arms.
|
Lock pulse only when its Unlock
|
—
|
—
|
16| Cold Start Timer| 3 hours at -5oc/Runtime| 1.5 hours at -5oc/Runtime| 3
hours at -5oc/5 minutes| 1.5 hours at -5oc/5 minutes| Cold time OFF| —|
17| —| —| —| —| —| —| —|
18
|
Diesel Mode
|
Disable
| Enable (20 seconds)
The delay between Ignition power up and Starter (crank).
| Enable (10 seconds)
Delay between Ignition power up and Starter (crank).
| Enable
No delay between Ignition power up and Starter (crank).
| Enable (5 seconds) Delay between Ignition power up and Starter (crank).|
—
|
19| Turbo timer| Disable| Run 2 minutes.| Run 4 minutes.| —| —| —|
20
|
Engine supervision:
-Touchless –
-analog tach-
-Tach Data-Link-
|
Touchless on crank and supervision Tach Data-Link.
|
Touchless only.
( vehicles with automatic transmission only)
|
Start (Crank) 20 sec + Supervision by Data-LInk Tach
|
Start (crank) 8 seconds on Touchless.
( vehicles with automatic transmission only)
|
Start (Crank) 8 sec + Supervision by Data-LInk Tach
|
Tach Data-Link only
|
21| Start Attempts| 2| 1| 3| —| —| —|
22| —| —| —| —| —| —| —|
23
|
Master RESET
| RESET all programming options by default. (Retains already programmed remotely.)|
—
|
—
|
—
|
—
|
—
|
24| —| —| —| —| —| —| —|
25
| Yellow/Black (A13) : Aux1 –> LOCK| 0.5 seconds & disarm alarm|
0.5 seconds
| 10 sec latch or until a button is pressed| 20-sec latch or until a button is pressed| 30-sec latch or until a button is pressed|
Latch until shutdown
|
26| Hybrid mode| Gas / Diesel vehicle| Hybrid vehicle| —| —| —| —|
27| —| —| —| —| —| —| —|
28| —| —| —| —| —| —| —|
29| Alarm Duration| 30 seconds| 60 seconds| 120 seconds| —| —| —|
30
|
Valet code
|
Ignition ON Valet button x3 times.
| Ignition ON Valet button x3 times
and x1 times 3 seconds.
| Ignition ON Valet button x4 times
and x1 times 3 seconds.
| Ignition ON Valet button x5 times
and x1 times 3 seconds.
| Ignition ON Valet button x6
times and x1 times 3 seconds.
| Ignition ON Valet button x7 times and x1 times 3 sec.|
31
|
Special application Programmable output (+)
|
No special application Priority on function 2
| Special application – Function 2 (all option) not available.| White| (+)
Parking Lights| White| (+) Parking Lights| White:(+) Parking- Lights|
Orange| (+) Accessory| Orange| Ign.2| Orange:(+) Parking lights|
White wire (E1) : Enable at ground out, disable with vehicle ignition OFF.
|
White wire (E1) : Trunk Output
|
Pink| (+) Ignition| Pink| Ign.1| Pink:(+) Ignition|
Yellow| (+) Start| Yellow| (+) Start| Yellow:(+) Start|
| FUNCTION| MODE 1| MODE 2| MODE 3| MODE 4| MODE 5| MODE 6
---|---|---|---|---|---|---|---
32
|
Ground Out
| Dk.Blue (Ground out): Shut-down 1 second after remote start run time.| Dk.Blue (Ground out): Shut-down 3 seconds after remote start run time.| Dk.Blue (Ground Out): Shutdown After| D.k Blue (Ground Out):
Starter-Kill
| D.k Blue (Ground Out): Arm / Rearm| Controlled by CAN learning
33| Manual transmission function| Manual transmission completed by door
closed.| Automatically activated by hand- brake and Foot Brake| Manual
sequence completed by locking the doors| Cancel ready mode when trunk open.|
—| —
34| Trunk output| Pulse 0.5 seconds| Pulse 2.5 seconds| Unlock before trunk
pulse 0.5sec| Trunk Output at ignition only| —| —
35| Door unlock Special application| No special application| Activate vehicle
ignition at unlock.| Activate vehicle ignition and accessory at unlock.| —| —|
—
36| Activation/desactivation remote Valet Mode| —| by remote : FUNCTION –>
LOCK + UNLOCK or valet button| By Valet button only| —| —| —
37
| Security Remote car starter
Special application
|
No special application
| Security ON: Shutdown Engine if the door is opened before UNLOCK is pressed. (Door trigger required).|
—
|
—
|
—
|
—
38| System control by OEM Remote| Disable| Press 3x Lock to remote start| Start/Stop on trigger shock sensor| Alarm control by OEM Remote.| Press Lock, Unlock Lock to remote start| —
39
|
Temperature option
|
Disable
| Enable : AUX1 activated at 5oc when remote started (see function 25)|
—
|
—
|
—
|
—
LEGEND: FUNCTION BY DEFAULT
MANUAL TRANSMISSION SEQUENCE FOR COMPATIBLE VEHICLES ONLY
WILL DISABLE MANUAL TRANSMISSION SEQUENCE
- STANDARD
- Open any door(s)
- Open the hood
- Disengage the parking brake
Note : If the Parking lights flash 3 times when Remote-Starting, Ready Mode is not enabled.
TO ENABLE COLD START MODE
Press and release the FUNCTION button, within 12 seconds simultaneously
press and and hold the LOCK and START buttons for 1 second. The parking lights
will flash once.
- Press and release the FUNCTION button, within 12 seconds simultaneously press and and hold the LOCK and START buttons for 1 second. The parking lights will flash twice.
- Put the Remote-Starter/alarm into Valet
- Remote-Start the vehicle
- Open the hood
- Press the brake pedal
- Turn the key to the ignition position.
- Disable Ready Mode (manual transmission).
DISARM / ENTER / EXIT VALET MODE
REMOTE START DIAGNOSTICS
Parking Lights flashes (before starting) :
- 3x Ready mode disabled
- 4x Valet mode activated (The LED is on)
- 5x Hood open
Parking Lights flashes (after Shutdown) :
- Normal stop (Brake, Park Brake)
- Runtime expired or shut down by transmitter
- No tachometer signal
- Hood open
- Over crank threshold (8 seconds)
ALARM DIAGNOSTICS
Parking Lights flashes (after disarm) :
- Door open – zone 3
- Shock sensor – zone 4
- Hood open – zone 5
- Trunk open – zone 6
WARNING
NOTICE The manufacturer will accept no responsibility for any electrical damage resulting from improper installation of the product, including either damage to the vehicle itself or to the remote-starter module. This module must be installed by a certified technician including all of the supplied safety devices. Please note that this guide has been written for trained professional technicians, a certain level of skills and knowledge is therefore assumed. Please review the Installation Guide carefully before beginning any work.
WARNING
By default, this system is setup for vehicles with a manual transmission.
For vehicles with an automatic transmission, the safety wire loop on the main
unit must be cut. Before proceeding to the installation, make sure that the
vehicle does not attempt to start when the vehicle is in the “drive” or
“reverse” position. If an automatic transmission vehicle starts when the
transmission is in gear, ensure that the safety wire loop on the unit is not
cut. Once the safety wire loop is cut, the system is considered an automatic
transmission remote-starter indefinitely. Once a loop is cut all warranties,
guarantees, and liability is immediately void if the unit is installed on a
manual transmission vehicle. Neither the manufacturer or distributor of this
module is responsible of damages of any kind indirectly or directly caused by
this module, except for the replacement of this module in case of
manufacturing defects. This module must be installed by a qualified
technician. This instruction guide may change without notice. To download the
installation guide, user guide, or the latest quick installation guide, visit:
WWW.FORTIN.CA
Technical support: TEL:
514-255-4357 /
1-877-336-7797
Copyright © 2014-2021, FORTIN AUTO RADIO INC ALL RIGHTS RESERVED MADE IN
CANADA
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>