FLYDIGI B5X Mobile Phone Cooling Fan User Manual

FLYDIGI B5X Mobile Phone Cooling Fan

Mount Magnetic sheet

*（Skip this step if there is magnetic function to your phone）**

1. Clean up your device before applying.
2. Remove film 1 off protective film, apply to target area, press to eliminate air bubbles. Then remove film 2.
3. Attach magnetic sheet to protective film. Set it aside for 1 hour before use.
   

Mount Cooling Fan

1. Connect charging cable, turn on cooling fan. Cooling system starts to work.
2. 5V 2A or higher charger output is required.

| Scanning QR code (left) to download Flydigi Game Center.
Cooling fan connected, you can use below functions:

1. Smart Frequency Conversion
   B5X auto adjusts cooling power for safe use of your phone.

2. Overclocking Cooling (OC) Mode
   Extra cooling capacity to excede your expectation.
   18W or higher charger input is required to use OC funtion.

3. RGB light
   RGB light display.

---|---
| Scan QR code (left) to learn more about Flydigi products info and services.
---|---

Product Specifications

Product name: Flydigi Mobile Phone Cooling Fan B5X
Product model: Flydigi B5X
Package contents: Magnetic cooling fan1, user manual1, charging cable1, magnetic sheet1

Q&A

1. Why RGB light display automatically turning off ?
   RGB light is set to dim in vibriancy as radiator power decreases

2. Is 18w or higher charger power neccesary ?
   18w or higher charger power needed only for using OC funtion.

Notes

1. Please make sure you read through all safety information before using device.
2. Do not insert fingers or foreign objects into or block the air inlet to avoid damage or overheating of the product.Please do not block air inlet to aviod damage or overheating of device.
3. Warning: This device contains magnets that may interfer with functioning of implantable medical devices or personal medical devices, such as pacemakers, cochlear implants, hearing aids, etc. It is suggested that a distance of 15cm or above be kept between the said medical devices and B5X.

Federal Communications Commission (FCC) Statement

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction Federal Communication Commission (FCC) Radiation Exposure Statement Power is so low that no RF exposure calculation is needed.

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications or changes to this equipment. Such modifications or changes could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/ TV technician for help.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>