Shanghai Flydigi Electronics Technology X1 True Wireless Earphones User Manual
- June 6, 2024
- Shanghai Flydigi Electronics Technology
Table of Contents
Shanghai Flydigi Electronics Technology X1 True Wireless Earphones User
Manual
New Generation Flydigi Foxspeed™ Low Latency Technology.
Real Latency-Insensitive Wireless Sound Experience
Connection to Phone
Open earphone case. Turn on bluetooth and choose “FLYDIGI Cyberfox Xl”
Connection to Other Devices
Open earphone case and long press “connect button” for 3 seconds until you see an alternation of blue and red blinks. Then go to bluetooth setting-Bluetooth- Choose “FLYDIGI Cyberfox X1”
Button Instructions
Left tap thrice to activate voice helper Right tap thrice to turn on/off Latency Mode
“Dodododo”4 Beeps: Ultralow Latency Mode Exclusively designed for gaming.
“Dodo” Beeps: Classic Mode, perfect for Music/Entertainment.
- Double press to Play/Pause
- Double press to Answer/Hang up
- Left long press 2 seconds to return
- Right long press 2 seconds to skip
- Long press 2 seconds to decline incoming call
Charging
- Charging: steady red light.
- Full charge: steady blue light.
- Battery life below 20%: in red light after opening case.
- Battery life above 20%: in blue light after opening case.
Charging Earbuds
**Place FLYDIGI Cyberfox X1 in case to recharge
**
Pairing
Pair with Flydigi Peripheral Family, Games Have Never Been Easier to Play
- Shadow Stinger
- Wasp Wing 2 Pro
- Wasp 2 One-handed Controller
Download Flydigi Game Center
Subscribe To Our WeChat
FAQ
Q: Why only one side have sound or have two same earbuds in Bluetooth
list
A: Please reset the earbuds by holding the pair button on the case for
15S till the Red flash, Keep holding it until red and blue flash. The reset is
complete.
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note:This equipment has been tested and found to comply with the limits for a class B digital device,pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,may cause harmful interference to radio communications.However,there is no guarantee that interference will not occur in a particular installation.if this equipment does cause harmful interference to radio or television reception,which can be determined by turning the equipment off and on,the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an autlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>