FLYDIGI Vader 2 Wireless Game Controller User Manual
- June 5, 2024
- FLYDIGI
Table of Contents
FLYDIGI Vader 2 Wireless Game Controller
Basic Operation
W V e i r s e i l o e n ss
| Power On/OFF| Turn the power switch to ON/OFF
---|---|---
Standby| Out of use over 15 minutes, the controller will standby
automatically.
Low Battery| The status led 2 flashes in red when the battery is less than 10%
Charging| Connect the charger port to the USB cable, the status led 2 lights
on in green
Charge OK| Charge OK, the status led 2 lights off
W V e i r s e i d on| Power On/OFF|
Plug in/unplug the data cable
Standby| If it’s out of use over 15 minutes, the controller will standby
automatically.
Connection Instruction
| You wish to use | Connect to mobilephone, tablet | Connect to PC |
|---|---|---|
| Connection Mode | Press“+”and“B”simultaneously for 3 seconds Bluetooth | |
| Press“+”and ”A”simultaneously for 3 seconds 2.4G dongle | Connect the USB cable |
to computer USB cable
Support Mode| Bluetooth Mode| 360 Mode Android Mode
Indicator Instruction| Status led 1 blue| Status led 2 white
Press “+” and “Select” for 3 seconds to switch between 360 mode and andriod mode, strong rumble when switching to 360 mode, weak rumble when switching to andriod mode
Use on computer
Download the software
Use the browser to access to down.flydigi.com to download the software
Play PC game
With 360 mode, you can play GTA5, Assassin’s Creed, Resident Evil and Tomb
Raider directly. With android mode, you can play android games on the
computer’s android emulator.
Use on mobile phone, tablet (Only for Wireless Version)
STEP1: Download the Flydigi Game Center App
Scan the QR code, then download and install the Flydigi Game Center App. IOS
only support below 13.4 Or use the browser to access to down.flydigi.com to
download
STEP2: Bluetooth connects to phone
According to Flydigi Game Center ‒Setting Management, click to connect to
phone, connect the controller as the game center guides.
Federal Communications Commission (FCC) Statement
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications or changes to this equipment. Such modifications or changes could void the user’s authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. IF this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- eorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- consult the dealer or an experienced radio/ TV technician for help.