MOEN YB0424BN Align 24 Inch Towel Bar, Brushed Nickel Instructions
- June 5, 2024
- Moen
Table of Contents
Installation Instructions for Towel Ring, 18 in.
and 24 in. Towel Bars, and Pivoting
Paper Holder
Don’t forget to register and review your product by visitingmoen.com /product-registration.
Tools Required:
- Phillips screwdriver,
- drill, 1/4” drill bit,
- hammer,
- level,
- tape
Hardware Kit Contents:
- 4 anchors,
- 1 hex wrench
Note: Directions below are for installation into drywall. If installing a product into a stud, use the wood screws only.
- Position the mounting template on the wall in the desired location.
- Using a level, align the template and tape it to the wall.
- Drill two 1/4” holes at each mounting post location that corresponds to your product. (We recommend using the horizontal holes for drywall installation).
- Remove the template from the wall.
- Lightly tap anchors until flush with the wall.
- Remove mounting posts from the product assemblies by loosening each setscrew.
- One at a time, place each mounting post over anchors (notch facing downward) and insert screws through the post into anchors.
- Tighten screws.
Towel Bars
9) Assemble the towel bar and posts.
10) While assembled, position each end post with setscrews facing down
and place them over both mounting posts. Tighten the setscrew at the bottom of
each post.
Pivoting Paper Holder
9) Place each assembly over the mounting posts with setscrews facing
down.
Pivoting post with bar should be on the left side. Tighten both setscrews.
Position bracket and drill holes as indicated
Align™
Align is a trademark of Moen® Incorporated ©2019
25300 Al Moen Drive
North Olmsted, OH 44070-8022
Customer Service USA:
1-800-882-0116
International Customer Service:
1-440-962-2217
www.moen.com
YB04
INS10732
05/19
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>