SUPER BRIGHT LEDS LPD-TWR Series LPD-TWR24-50 Tunable White LED Panel Light User Manual
- June 5, 2024
- super bright leds
Table of Contents
SUPER BRIGHT LEDS LPD-TWR Series LPD-TWR24-50 Tunable White LED Panel
Light
Included Parts
LED Panel Ceiling Light
Wire Nuts
Safety and Notes
-
Product should be installed by a certified electrician in accordance with applicable national, state, and local building and electrical codes.
-
To reduce the risk of electric shock, ensure that the main power source and circuit breakers are switched off before performing any installation or wiring procedures.
Avoid looking directly into the light when illuminated. -
Failure to properly support the fixture may result in damage or injury, for which the manufacturer does not assume responsibility. A safety cable is not included, but it is recommended that one be connected to grid clip during installation.
Recommended Accessories
- Handheld Remote Control (LPD-TWHR)
- Wall-mount Controller (LPD-TWWR)
Optional Accessories
- Optional Suspension Kit (LP-HKO-2)
- Surface Mount Kit (LP-22-SMK for 2×2, LP-24-SMK for 2×4)
Specifications
| Model | LPD-TWRx-x |
|---|---|
| Operating Temperature | -4°–113° F (-20°–45° C) |
| IP Rating | IP20 |
Check product label for specific electrical specifications related to installation. Improper installation will void warranty.
Recessed Installation
- Disconnect supply power and remove existing troffer light or ceiling tile.
- Make electrical connections.
- Bend out safety tabs to be vertical, then bend upper portion out 90 degrees.
- Lay fixture into T-grid.
Optional Suspension Kit (LP-HKO-2) Installation
- Mount suspension hardware to ceiling.
- Hang panel from suspension cables using cable clamp to secure.
Linking Single Controller
Handheld Remote Control
Hold the “ID” button (the controller’s indicator light will stay on) and turn
the light panel on. The light panel will flash to indicate the process is
successful, at which point the “ID” button can be released. Hold “ID” and ▼
buttons and turn the light panel on to unlink the remote from the light panel.
Wall-mount Controller
Hold the “ON” and “OFF” buttons (the controller’s indicator light will stay
on) and turn the light panel on. After the light has been on for 3–5 seconds,
release buttons and check to ensure linking
Linking Multiple Controllers
If using both the handheld controller and wall-mount controller, the wall controller can copy some of the functions of the hand-hold controller by holding the following buttons simultaneously for a few seconds until indicator light turns solid.
Controllers
LPD-TWHR
LPD-TWWR
Documents / Resources
|
SUPER BRIGHT LEDS LPD-TWR Series LPD-TWR24-50 Tunable White LED Panel
Light
[pdf] User Manual
LPD-TWR Series, LPD-TWR24-50, Tunable White LED Panel Light
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>