SDC LR100FAK-EM Electric Latch Retraction Kit Instruction Manual
- June 4, 2024
- SDC
Table of Contents
INSTALLATION INSTRUCTIONS
LR100FAK-EM
ELECTRIC LATCH RETRACTION KIT
EXTERNAL MODULE FALCON (Dor-O-Matic) MODELS: 1690 & 1790
Retrofit Installation Note:
42″ or 48″ exit devices that have been modified to fit a 36″ or smaller
opening, may not have the required space to fit the standard E. L. R.
assembly. Always verify the distance from the end of the touchpad to the end
rail, and if necessary, consult with the factory for appropriate selection.
Remove Push Bar. Remove Dogging Assembly. Slide the ELR unit into the device
base. Align the first set of two holes over the two base unit holes and attach
with the two #10-32 flat head screws supplied. Attach the Linkage to the
device as shown. Re-attach the Push Bar.
Any suggestions or comments on this instruction or product are welcome. Please contact us through our website or email engineer@sdcsecurity.com
NOTE Retro-Fitting Vertical Rod Devices:
Before retrofitting an electric latch assembly into a vertical device, the following must be done to ensure proper alignment. Disconnect the vertical rods from the device. Install the electric latch assembly as shown above. Once the ELR is properly installed energize it so that the push pad is dogged down, by doing so it will allow for proper alignment for the vertical rods. Finally, reconnect the vertical rods to the device and make the proper adjustments.
ALIGN TEMPLATE TO EXISTING HOLES, FALCON/DOR-O-MATIC or FIRST CHOICE
MARK AND DRILL 1 HOLE FOR 10-32 FLT HD
SECURITY DOOR CONTROLS
WWW.SDCSECURITY.COM
[t] 800.413.8783
805.494.0622
E-mail:service@sdcsecurity.com
801 Avenida Acaso, Camarillo, CA 93012
PO Box 3670, Camarillo, CA 93011
P:\INST INSTRUCTIONS\ELR KITS\INST-LR100FAK_FCK-EM REV
Documents / Resources
| SDC
LR100FAK-EM Electric Latch Retraction
Kit
[pdf] Instruction Manual
LR100FAK-EM, Electric Latch Retraction Kit, LR100FAK-EM Electric Latch
Retraction Kit
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>