THULE 307919 Adaptor Omnistor Eden Instructions
- June 3, 2024
- THULE
Table of Contents
THULE 307919 Adaptor Omnistor Eden
Read these instructions carefully. No guarantee will be allowed for the wrong installation.
APPLICATION
Adapter set for the installation of the Thule Omnistor 5000 awning on the following camper types:
- Challenger type Eden 202 (3.00m), 402, 502, and 602 (3.50m)
- Chausson type Allegro A62 (3.00m), A6/, A68 and A69 (3.50m).
- Full-length adapter for general mounting of a Thule Omnistor series 5 awning:
- 3.00m – 3.50m -4.00m.
CONTENTS OF SET
INSTALLATION
1. Position the adapters on the vehicle as shown in fig. 1 or 2.
2. Adapter set: Fix the adapters to the wall according to figures A, B, C,
and D, taking care of the following points:
- Make sure that the adapters are well aligned.
- Put acid-free silicone paste or butyl kit into the drilled holes.
- Adapter 70 cm: Only use the holes indicated on the drawing for there’s enough space left for the counter plates at
- the inside of the vehicle. For a supplementary fixation turn the screw 4,2×25 into a free hole (fixation B).
- Adapter 30 cm Counter drill from inside (I? Jl 2.5), for pl;citing the f ill -out t tubes, only as deep as the wall this knees S (do not drill throughout the roof plate)
- Put SIKA 221 glue on the back of the adapters before f ix ing them
- Fasten the bolts carefully in order not to damage the lacquer of the roof.
Adapter Eden – Allegro
- Full-length adapter. see installation instructions for the awning. Place the profile sO that enough space is left for the
- Counter plates at the inner side of the vehicle. In conflict new holes (D) can be drilled while respecting the same Target.
- Hang the awning in the adapters. Saw oft the annoying part of the ornamental border above the joint of the roofs (only for campers type Eden or Allegro).
- Drill at the bottom of the box dia. 4mm holes and fix the awning to each adapter with 4.2×16 Screws from the Thule
- Omnistor 5000 installation kit. See the installation instructions enclosed with the awning.
REMARKS
-
Leave the awning open for 5 cm while the glue is drying. In this position, there will be no torsion on the adapters.
-
In order not to damage the vehicle wall. never roll out the awning completely without getting the support arms ou
-
Check regularly if the adapters are still well fixed to the vehicle.
-
Thule NV, Kortrijkstraat 343 – BE 8930 Menen, BELGIUM
-
infoRV@thule.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>