SUPER BRIGHT LEDS LPDBL-U1 Series Dimmable Backlit LED Panel Light User Manual
- June 5, 2024
- super bright leds
Table of Contents
LPDBL-U1 Series Dimmable Backlit LED Panel Light
User Manual
LPDBL-U1-22-SW3C-SP40 Fixture
Important: Read all instructions prior to installation.
Safety and Notes
- The product should be installed and serviced in accordance with applicable national, state, and local building and electrical codes.
- To reduce the risk of electric shock, ensure that the main power source and circuit breakers are switched off before performing any installation or wiring procedures.
- Avoid looking directly into the lamp when illuminated.
- Ensure all mounts are securely attached and will support the weight of the fixture. Failure to properly support fixtures may result in damage or injury, for which the manufacturer does not assume responsibility.
Installation
- Turn supply power to circuit off. If installing as a retrofit, remove the existing fixture.
- Open driver box and remove knockout(s) for wiring. Make electrical connections using the wiring diagram. Once complete, resecure the driver box cover.
- Select wattage and CCT using built-in switches on the driver box.
- Bend out safety tab to be vertical, then upper portion out 90 degrees. It is recommended that a safety cable be installed to anchor the fixture as well.
- Lay fixture into T-grid.
Note: Tabs should secure the light in T-grid while still allowing reinstallation of adjacent ceiling tiles.
Wiring Diagram
Specifications
| Model | LPDBL-U1-22-SW3C-SP40 | LPDBL-U1-22-SW3C-SP50 |
|---|---|---|
| Operating Temperature | -4°–113° F (-20°–45° C) | |
| IP Rating | IP40 |
Check the product labels for specific electrical specifications related to installation. Improper installation will void the warranty.
4400 Earth City Expy, St. Louis, MO 63045
866-590-3533
superbrightleds.com
Rev Date: V1 08/03/2021
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>