SUPER BRIGHT LEDS WPA-SW3B15W-H8DBR35 Selectable CCT Adjustable Angle LED Wall Pack User Manual
- June 5, 2024
- super bright leds
Table of Contents
WPA-SW3B15W-H8DBR35 Selectable CCT Adjustable Angle LED Wall Pack
User Manual
Important: Read all instructions prior to installation.
Safety and Notes
- The product should be installed and serviced by a certified electrician in accordance with applicable national, state, and local building and electrical codes.
- To reduce the risk of electric shock, ensure that the main power source and circuit breakers are switched off before performing any installation or wiring procedures. Wiring/installation should not be attempted during inclement weather.
- Ensure all amounts are securely attached and will support the weight of the fixture. Failure to properly support the fixture may result in damage or injury, for which the manufacturer does not assume responsibility.
- Minimum 90° C supply conductors
Installation
-
Loosen light angle adjustment bolts and rotate the light up.
-
Remove two screws that hold the front and rear housing together.
-
Rotate light and front housing out, disconnect photocell, and lift off of rear housing.
-
Drill holes in the rear housing as needed.
-
With supply power turned off, run wiring through rear housing (junction box) or conduit hole on side of the housing and mount housing to junction box/wall using included rear gasket.
-
Slide front housing and light back onto the rear housing in the open position and connect wiring.
Note: if unneeded, unplug photocell and cap connections to bypass it. -
Close the light fixture and secure it with two screws.
-
Apply power. Use an adjustment bolt to set the light at the desired angle.
Note: Light angle can be adjusted in 15° increments within a 90° range.
Wiring Diagram
120–277 VAC Input
0–10 V Dimming
Specifications
| Model | WPA-SW3BxW-H8DBR35- |
|---|---|
| Operating Temperature | -40°–122° F (-40°–50° C) |
| IP Rating | IP65 |
| Dimming | 0–10 V |
Check the product labels for specific electrical specifications related to installation. Improper installation will void the warranty.
CCT Selection
Field-selectable CCT can be set using the internal switch as shown. Make certain supply power is off when performing this procedure.
Built-in Photocell
The photocell will turn the light on when the ambient light level falls below 30 lux. When ambient light rises back above 130 lux (15 W, 30 W, 80 W) or 60 lux (120 W) the light will turn back off. The photocell can be bypassed by unplugging it inside the housing and capping the wire end plug.
4400 Earth City Expy, St. Louis, MO 63045
866-590-3533
superbrightleds.com
Rev Date: V1.0 08/24/2021
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>