Super Bright LEDs BRI619 0-10 Volt Low Voltage PIR Motion Sensor User Manual
- June 5, 2024
- super bright leds
Table of Contents
Super Bright LEDs BRI619 0-10 Volt Low Voltage PIR Motion Sensor
Safety and Notes
- The product should be installed and serviced by a certified electrician in accordance with applicable national, state, and local building and electrical codes.
- To reduce the risk of electric shock, ensure that the main power source and circuit breakers are switched off before performing any installation or wiring procedures.
Specifications
| Model | BRI619 |
|---|---|
| Maximum Detection Radius | 29.5 ft (9 m) |
| Maximum Mounting Height | 39.4 ft (12 m) |
| Operating Temperature | -40°–167° F (-40°–75° C) |
| Dimming | 0–10 V ¹ |
Default Settings
Model| Sensitivity| Hold On Time| Daylight Sensor|
Dimming Level| Dimming Time
---|---|---|---|---|---
BRI619| 100%| 15 min| 30 lux| 30%| 60 minutes
DIP Switch Settings
Setting| Sensitivity| Time| Light| Standby Level|
Standby Time
---|---|---|---|---|---
Switch Pair Position| 1 and 2| 3 and 4| 5 and 6| 7 and
8| 9 and 10
| ****
20%
| ****
10 seconds
| ****
disabled
| ****
0%
| ****
always on
| ****
50%
| ****
1 minute
| ****
10 lx
| ****
10%
| ****
1 minute
| ****
75%
| ****
5 minutes
| ****
30 lx
| ****
30%
| ****
30 minutes
| ****
100%
| ****
15 minutes
| ****
50 lx
| ****
50%
| ****
60 minutes
- Sensitivity adjusts detection range.
- Time adjusts the amount of time before the light enters standby mode when no motion is detected.
- Light adjusts the ambient light threshold (photocell operation).
- Standby Level adjusts the dimming level in standby mode.
- Standby Time adjusts the amount of time between entering standby mode and fully disabling light.
Motion Sensor
Installation
- Remove supply power from
- Remove two bolts to open access
- Drill 1 5/16 in. hole in pre-marked
- Place module through hole, then install rubber gasket and locking
- Plug sensor into
- Wire using wiring diagram
- Close and secure panel then reapply supply.
Wiring Diagram
Note: Sensor uses 12–24 VDC input only
Documents / Resources
|
Super Bright LEDs BRI619 0-10 Volt Low Voltage PIR Motion
Sensor
[pdf] User Manual
BRI619, 0-10 Volt Low Voltage PIR Motion Sensor
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>