SUPER BRIGHT LEDS MCBRF-15ALC2 Single Color LED Controller with Wireless RF Remote User Manual

SUPER BRIGHT LEDS MCBRF-15ALC2 Single Color LED Controller with Wireless

RF Remote

**Parts Included

**

• 1 – LED Controller
• 1 – Wireless Remote
• 1 – CR2025 Battery

**Wireless Remote Functions

**

1. Turn On(|) / Standby(O)
   Press ‘I’ button to turn on unit or press ‘O’ button to turn off.
   Retains last setting between power off and power on.

2. BRIGHT(+)/BRIGHT(-) Dimming Level
   Increases(+) or decreases(-) the brightness level of the light. Initiates Brightness Level Mode if Dynamic Mode is currently active.
   3. Brightness Shortcuts
   Activates the brightness level indicated on the button label. These individual brightness levels are also accessible through the Bright(+)/Bright(-) buttons.

3. Mode(+)/Mode(-) Dynamic Modes
   Dynamic modes feature a variety of brightness transitions and patterns, with 8 distinct modes. These buttons initiate Dynamic Mode and cycle through the modes in ascending or descending order.

4. SPEED(+)/SPEED(-) Dynamic Modes Speed Level
   Increases(+) or decreases(-) the speed of the currently active dynamic mode. Initiates Dynamic Mode if Brightness Level Mode is currently active.

5. Wireless Remote LED Indicator
   Flashes blue when remote is operating to indicate that the remote is functioning properly.

SPECIFICATIONS

Controller Installation

1. Power Supply Input
   The controller/power supply operates at 5-24VDC. The red wire is positive(+) and the black wire is negative(-) as indicated on the controller housing. Make sure the power voltage matches the LED strip requirement. Incorrect voltage may damage the LED strip.

2. Output to LEDs
   The red cable should be connected to LED positive and black cable to negative.
   The peak output current is 15 amperes.
   CAUTION! Do not short circuit or overload the LED outputs, this may lead to permanent damage!

3. LED Controller Status Indicator
   A multi-color emitting LED located on the remote controller indicates current operating status or operating status changes as follows:

LED Controller Status Indicator

Light Signal

|

Blue

| Short single white flash| Long single

white flash

| Long single

yellow flash

|

Red flash

|

Yellow flash

Indicates

|

normal

function

|

mode change

|

Range limit has been reached when cycling through Dynamic Modes

| Range limit has been reached when cycling through Tempo Speed Level or Brightness Level|

Overload/short circuit has been detected, activating

protection mode

|

Overheating has been detected, activating protection mode

Using the Wireless Remote

Prepare the wireless remote for use by removing the battery insulator. The remote uses a CR2025 battery. Note: The wireless remote operates using radio frequency(RF). The remote controller’s use is not restricted by normal obstructions such as walls, doors, etc. Do not install controller in metal enclosures.

Remote Pairing

The included remote will already be paired to the controller. Up to 4 additional wireless remotes can be assigned to operate the LED controller. Additionally, each individual wireless remote can be assigned to an unlimited number of controllers.
Pairing:

1.  Disconnect the power to the LED controller, wait 5 seconds, and reconnect.
2.  Within 10 seconds of reconnecting the LED Controller, hold the “50%” and “10%” buttons simultaneously for about 3 seconds.
3.  The LED indicator on the LED controller will flash white 3 times indicating the new wireless remote has been successfully assigned. This may be done for a total of 5 wireless remotes.

Rev Date: V2.0 12/02/2021
4400 Earth City Expy, St. Louis, MO 63045
866-590-3533
superbrightleds.com

References

• LED Lighting For Everything | Super Bright LEDs

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>