Teesa TSA0560 Hair Styling DREAM CURLS X600 Automatic Curler Owner’s Manual
- June 3, 2024
- teesa
Table of Contents
Automatic hair curler
DREAM CURLS X600
TSA0560
Owner’s manual
Thank you for purchasing the TEESA appliance. Please read this operation instruction carefully before use, and keep it for future use. The distributor does not take responsibility for damages caused by inappropriate handling and use of the product.
SAFETY INSTRUCTIONS
In order to reduce the risk of fire, electric shock, or any other injury, follow basic safety precautions are applied when using any electrical device, including the following:
-
Read this instruction manual carefully, even if you are familiar with the appliance. Keep the manual for future reference.
-
Before connecting the appliance to the power supply socket, make sure the voltage indicated on the appliance corresponds to the voltage in the power supply socket.
-
Product intended for household use only.
-
Do not use the product for purposes different from those displayed in this operating manual.
-
Clean and store this appliance in accordance to the instructions listed in the “Cleaning” and “Storage” sections.
-
ALWAYS turn off the device:
• if it’s not operating correctly,
• if there’s an uncommon voice when using,
• before disassembling the device,
• before cleaning,
• when not in use. -
When you disconnect the power cord of the appliance, grasp and pull the plug, not the cord/cable.
-
This appliance may be used by children who are above 8 years old and by persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge if they are supervised and guided by a person who is responsible for their safety in a cautious manner, and all the safety precautions are understood and followed. Children should not play with this device. Children should not perform cleaning and servicing of the device unsupervised.
-
Keep the appliance out of the reach of children.
-
Fixed power cables may only be replaced in an authorized service point.
-
Keep the appliance and its cord/cable away from heat, water, moisture, sharp edges, and any other factor which may damage the appliance or its cord.
-
Make sure the power cord does not touch any hot or sharp elements.
-
Use only authorized accessories.
-
DO NOT use this appliance if the cord or the plug is damaged, or the appliance is broken.
-
Do not attempt to repair this appliance yourself. Only authorized and qualified personnel may repair this appliance. Never disassemble this appliance.
-
In case of damage, contact an authorized service point for check-up/ repair.
IMPORTANT!
-
DO NOT PLACE THE APPLIANCE IN WATER OR ANY LIQUID; NOR HANDLE/ USE IT WITH WET OR MOIST HANDS.
-
DO NOT USE THE APPLIANCE NEAR WATER CONTAINED IN BATHTUBS, SINKS OR IN OTHER CONTAINERS. -
DO NOT PLACE OR STORE THE APPLIANCE WHERE IT CAN FALL OR BE PULLED INTO A TUB OR SINK.
-
DO NOT REACH FOR THE APPLIANCE THAT HAS FALLEN INTO THE WATER. UNPLUG IT IMMEDIATELY.
-
DO NOT DROP THE APPLIANCE OR SUBJECT IT TO STRONG IMPACTS.
-
DO NOT INSERT ANY OBJECTS INTO THE OPENINGS.
-
NEVER COVER THE APPLIANCE (WITH A BLANKET OR TOWEL) WHEN IT IS HOT.
-
DO NOT USE THE APPLIANCE OUTDOORS OR OPERATE IT WHERE AEROSOL (SPRAY) PRODUCTS ARE BEING USED OR WHERE OXYGEN IS
BEING ADMINISTRATED. -
DO NOT OPERATE THE APPLIANCE WITH AN EXTENSION CORD OR A VOLTAGE CONVERTER.
-
DO NOT LEAVE THE APPLIANCE UNATTENDED WHEN IT IS OPERATING.
-
THE APPLIANCE HAS A COOL-TOUCH HOUSING, NEVERTHELESS, THE CURLING IRON GETS VERY HOT DURING OPERATION. DO NOT TOUCH IT!
-
DO NOT WRAP THE POWER CORD AROUND THE APPLIANCE.
-
ONLY SMALL HAIR STRANDS MAY BE INSERTED INTO THE CURLING CHAMBER. TO SEPARATE PROPER STRANDS, PLEASE USE THE ACCESSORY INCLUDED IN THE SET.
-
DO NOT DIRECT HOT AIR TOWARD YOUR FACE OR ANY OTHER PARTS OF YOUR BODY NOR OTHER HEAT-SENSITIVE SURFACES.
-
DO NOT USE THE APPLIANCE ON WET HAIR.
SERVICING OF DOUBLE-INSULATED APPLIANCES
In a double-insulated appliance, two systems of insulation are provided
instead of grounding. No grounding means is provided on a double-insulated
appliance, nor should a means for grounding be added to the appliance.
Servicing double-insulated appliances requires extreme care and knowledge of
the system, and should be done only by qualified service personnel.
Replaceable parts for a double-insulated appliance must be identical to the
parts they replace. A double-insulated appliance is marked with the words
“DOUBLE INSULATION” or “DOUBLE INSULATED”. The symbol (square within a square)
may also be marked on the appliance.
POLARIZED PLUG
This appliance has a polarized plug (one blade is wider than the other). As a
safety feature, this plug will fit in a polarized outlet only one way. If the
plug does not fit fully in the outlet, reverse the plug. If it still does not
fit, contact a qualified electrician. Do not attempt to defeat this safety
feature.
PRODUCT DESCRIPTION
HAIR CURLER
- Hair fastening opening buttons
- Hair fastening
- Curling chamber opening
- Curling iron
- Swivel cord
- Hair sectioning accessory
LED DISPLAY
-
Mode button m
Press to switch between the curling direction and time settings. -
Adjustment button
**-**
Press to decrease temperature, and time and choose the curling direction. -
Power button
Press and hold for 3 seconds to turn on the appliance. Press and hold for 3 seconds to turn off the appliance. -
Adjustment button +
Press to increase temperature, time, and choose the curling direction.
CURLING SETTINGS
- 9 temperature settings (150°C – 230°C)
- 3 curling directions (left/ auto/ right)
- 4 curling time settings (8s/ 10s/ 12s/ 14s)
Temperature setting
Press the – button to decrease the temperature. Press the + button to increase
the temperature. When temperature increases to the desired level, the
flashes. When
the temperature reaches set level, the stops flashing and the appliance
beeps twice.
*** Every time the appliance is switched on, it returns to the default
temperature setting which is 210°C.
Temperature setting depends on the type of hair:
- 150°C – 190°C for delicate, fine or damaged hair
- 190°C – 210°C for normal textured hair
- 210°C – 230°C for thick hair
Curling direction setting (left/ auto/ right)
Press the Mode button **M** to switch to the curling direction setting (the
flashes).
Press the -/+ buttons to select left/ auto/ right curling direction. Press the
Mode button to confirm.
When set to LEFT, curl direction goes to left; set to AUTO, curl direction is
alternate, when set to RIGHT curl direction goes to right.
Curling time setting
Press the Mode button m to switch to the curling time setting (the flashes).
Press the – button to decrease curling time. Press the + button to increase
the curling time. Press the Mode button to confirm.
*** When adjusting curling settings, the appliance beeps once with each press of a button.
OPERATION
Prior to curling make sure that your hair is dry and combed through.
-
Connect the plug of the power cord to the power supply socket. The appliance will beep for 2 seconds to indicate that power is on. OFF will appear on the display.
-
Press and hold the Power button for 3 seconds to turn on the appliance (it will beep twice). The default temperature is 210°C, the curl direction is AUTO and the time is 12 seconds. Adjust desired settings (see “Curling settings”).
-
Wait until the appliance beeps twice; that indicates that the appliance reached the selected temperature.
Do not start curling until the appliance reached the selected temperature. -
Each time please select small hair strands. It is recommended to use the attached hair sectioning accessory to separate hair strands (especially when not acquainted with the appliance).
-
Use your thumb and forefinger to press the hair fastening opening buttons on both sides of the appliance to open the hair fastening. Make sure the open part of the hair chamber faces toward the head.
-
Put the upper part of the hair strand into the curling chamber opening and guide the remaining hair strand down the appliance ensuring it stays together. You can twist the section so that it will not split.
-
Release the hair fastening opening buttons- the hair fastening will close and hair will be automatically drawn into the hair chamber and start to curl. Do not open the hair fastening during the curling process. If opened, you need to take out the hair and put it into the curling chamber opening again.
-
During the curling process, the appliance issues beep at regular intervals.
-
When the appliance issues four beeps, press and holds the hair fastening opening buttons to open the hair fastening and slowly move down the appliance, taking out the curl.
-
Repeat those steps to create more curls.
-
After use, turn off the appliance by pressing the Power button and unplug it from the power supply socket.
-
Prior to cleaning and storing, make sure the appliance has cooled down completely.
-
Clean and store this appliance as described in the “Cleaning and storage” section.
TIPS:
- Always place the appliance with the open part of the curling chamber facing toward the head.
- Each time please select small hair strands. The less hair you put in, the better results you will get (small sections create tighter curls, and larger sections create looser curls).
- In order to keep better curl results, please do not comb your hair before they cool down.
SLEEP MODE AND AUTO SWITCH OFF
After 20 minutes of no operation, the appliance will enter sleep mode. After another 40 minutes, it will turn off automatically.
HAIR DETECTION
When you open the hair entrance and put your hair into the curling chamber, the appliance will detect that hair goes in and activate the motor. If no hair goes in, the motor will stop after one turn and beep once.
CLEANING AND STORAGE
- Before cleaning makes sure the appliance has cooled down completely.
- Clean the appliance with a soft and dry cloth.
- Do not use any abrasives or cleaning agents to clean this appliance.
- Store the appliance in a cool, well-ventilated place.
- When storing, make sure the power cord is not wound around the appliance.
TROUBLESHOOTING
| PROBLEM | POSSIBLE REASON | POSSIBLE SOLUTION |
|---|---|---|
| There is nothing on the display and the appliance cannot turn on | The plug is | |
| not inserted into the power supply socket properly | Check if the plug is |
connected properly
The motor stops working after one turn| No hair went into the curling chamber;
the hair detection system did not identify hair going into the curling chamber
(the sensor is dirty)| Open the hair fastening and put hair into the curling
chamber; clean the curling chamber (only when the
the appliance has cooled down completely!)
ERR appears on the display| Temperature sensor malfunction| Contact with an
authorized service for check-ups/repair
The motor is stuck| Strand is too big| Put an appropriate amount of hair into
the curling chamber
The motor does not turn| Only one part of the hair fastening has been opened|
Make sure you press both hair-fastening opening buttons on the sides of the
appliance
SPECIFICATION
MAIN FEATURES
Suitable for all hair lengths and types
Innovative design
Brushless motor
Titanium-coated curling iron
Protection against hair trapping
Hair detector
LCD display
Beep indicator| Heats up in less than one minute
Sleep mode (after 20 mins)
Auto switch off (after 60 mins)
Cool-touch housing
360° swivel cord
Upright storage
---|---
TECHNICAL DATA
Power: 20 W
9 temperature settings: 150°C/ 160°C/ 170°C/ 180°C/ 190°C/ 200°C/ 210°C/
220°C/ 230°C
4 time settings: 8s/ 10s/ 12s/ 14s
3 curling directions: left/ auto/ right
Power supply: 100 – 240 V; 50/60 Hz
Weight: 585 g
Dimensions: 95,5 x 160 x 65,5 mm
Power cord length: 2,8 m
In set: hair sectioning accessory
Correct Disposal of This Product
(Waste Electrical & Electronic Equipment)
(Applicable in the European Union and other European countries with separate
collection systems) This marking shown on the product or Its literature
indicates that It should not be disposed of with other household wastes at the
end of its working life. To prevent possible harm to the environment or human
health from uncontrolled waste disposal, please separate this from other types
of waste and recycle it responsibly to promote the sustainable reuse of
material resources. Household users should contact either the retailer where
they purchased this product, or their local government office, for details of
where and how they can take this item for environmentally safe recycling.
Business users should contact their supplier and check the terms and
conditions of the purchase contract This product should not be mixed with
other commercial wastes for disposal.
Made in China for LECHPOL ELECTRONICS Sp. z o.o. Sp.k., ul. Garwolińska 1,
08-400 Miętne.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>