teesa TSA0115 Pure Life P500 Air Purifier Owner’s Manual

June 3, 2024
teesa

TSA0115 Pure Life P500 Air Purifier
Owner’s Manual

Thank you for purchasing TEESA appliance. Please read this operation instruction carefully before use, and keep it for future use. Distributor does not take responsibility for damages caused by inappropriate handling anduse of the product.

SAFETY INSTRUCTIONS

In order to reduce the injuries or damages, follow basic safety precautions applied when using any electrical device, including the following:

  1. Read this instruction manual carefully, even if you are familiar with the appliance. Keep  the manual for future reference.

  2. Before connecting the device to power supply socket, make sure the voltage indicated on the appliance corresponds to the voltage in the power supply socket.

  3. Place the device on flat, stable surface.

  4. Protect this device from shock and being dropped.

  5. Clean this device in accordance to instructions listed in “Cleaning and Maintenance” section.

  6. ALWAYS turn off the device and disconnect it from the mains supply:
    • if it’s not operating correctly,
    • if there’s an uncommon voice when using,
    • before disassembling the device,
    • before cleaning,
    • when not in use.

  7. When you disconnect the power cord of the device, grasp and pull the plug, not the cord/cable.

  8. This appliance may be used by children who are above 8 years old and by persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, if they are supervised and guided by a person who is responsible for their safety in a cautious manner, and all the safety precautions are understood and followed. Children should not play with this device. Children should not perform cleaning and servicing of the device unsupervised.

  9. Fixed power cable may only be replaced in an authorized service point.

  10. Keep the device and its cord/cable away from heat, water, moisture, sharp edges and any other factor which may damage the appliance or its cord.

  11. Do not place the appliance in water or any liquid; nor handle/use it with wet or moist hands.

  12. Do not use the product for purposes different from displayed in this operating manual.

  13. Do not use unauthorized accessories.

  14. Appliance for home use; do not use it for commercial or industrial purposes. Device for indoor use only.

  15. DO NOT use this device if the cord or the plug is damaged, or the appliance is broken.

  16. Do not attempt to repair this appliance yourself. Only authorized and qualified personnel may repair this device. Never disassemble this device.

  17. Do not insert your fingers or any other objects into the air inlet and outlet.

  18. Do not block or cover air inlet and outlet.

  19. Do not place anything on the top of the device.

  20. Do not place the device on soft surfaces such as bed or sofa as this could cause the device to tip over.

PRODUCT DESCRIPTION

Control panel

  1. Mode button
  2. Power button
  3. Timer button
  4. ON/OFF indicator
  5. Filter replacement indicator

Device

  1. Control panel
  2. Air outlet
  3. Air inlet
  4. Base
  5. Nut

3-STAGE FILTRATION SYSTEM

The air is purified with a 3-in-1 filter, consisting of pre-filter, HEPA filter and carbon filter. Each layer is responsible for eliminating different type of pollution.
Pre-filter: Captures big particles such as dust and hair
HEPA 11: Eliminates 99.5% of 0,3 μm particles such as dust, smoke, pollen and other allergens
Carbon filter: Removes odors and bad smells

OPERATION

  1. Prior to first use, take out the filter and remove the protective plastic bag then replace the filter (see “Filter replacement” section).

  2. Place the device on a flat and stable surface. Make sure there is enough space around the device to allow free circulation (at least one meter from walls or furniture) and that airinlet and outlet are not blocked.

  3. Connect the device to power mains.

  4. Press the power button to turn on the device (ON/OFF indicator lights up).
    Note: Press and hold the power button for about 5 seconds to reset the filter replacement indicator.

  5. Keep pressing the timer button to change timer intervals. There are three available timers: 2 hours, 4 hours and 8 hours. LED light indicates selected timer. When set time is up, the device will switch off automatically. If timer function is not enabled, the devicewill keep operating until manual switch-off.

  6. Keep pressing the mode button to change operation mode. There are four available modes: night, low, medium, turbo. LED light indicates selected mode.
    Notes:
    • Default operation mode is medium.
    • Turbo mode is on when all three indicators are on.
    • In the night mode, all indicators on the control panel are off.

  7. Turn off the device by pressing the power button and disconnect it from power supply (ON/OFF indicator goes off ).

FILTER REPLACEMENT

It is time to replace the filter when the filter replacement indicator lights up red. Filters should be replaced at least once each 6 months. More frequent cleaning and replacing may be required depending on environmental conditions.

  1. Turn the device upside down.
  2. Remove the screw from the base.
  3. Take off the base.
  4. Take out old filter and insert the new one.
  5. Reattach the base and fasten the screw.
  6. Set the device to proper position.
  7. Press and hold the power button for about 5 seconds to restart the system. The filter replacement indicator will go off.

3-in-1 filter is available to be bought from the online store Teesa.pl or rebelelectro.com.

CLEANING AND MAINTENANCE

  • Prior to cleaning, disconnect the device from power mains.
  • Clean the housing of the device regularly with a soft, slightly damp cloth.
  • 3-in-1 filter is NOT washable. Do not rinse it under water or immerse it in water. Make sure the filter is dry when installing it into the device.
  • The filter should be cleaned once a month with a vacuum cleaner.

SPECIFICATION

  • 3-stage filtration system
  • 4 fan operation modes
  • Sleep mode
  • Touch control panel
  • Filter replacement indicator
  • Quiet operation
  • Anti-slip feet

TECHNICAL DATA
Maximum room size: 15 m²
CADR: 136 m³/h
3-in-1 filter: pre-filter, carbon filter, HEPA 11
Operation modes: sleep, medium, high, turbo
Noise level: 29 dB/ 37 dB/ 47 dB/ 55 dB
Timer: 2 h/ 4 h/ 8 h
Power: 38 W
Power supply: 220 – 240 V; 50/60 Hz
Power cord length: 1,8 m
Weight: 3,1 kg
Dimensions: 233x233x342 mm

Correct Disposal of This Product
(Waste Electrical & Electronic Equipment)

(Applicable in the European Union and other European countries with separate collection systems) This  marking shown on the product or Its literature, indicates that It should not be disposed with other household  wastes at the end of its working life. To prevent possible harm lo the environment or human health from uncontrolled waste disposal, please separate this from other types of wastes and recycle it responsibly to promote the sustainable reuse of material resources. Household users should contact either the retailer where they purchased this product, or their local government office, for details of where and how they can take this item for environmentally safe recycling. Business users should contact their supplier and check the terms and conditions of the purchase contract This product should not be mixed with other commercial wastes for disposal.
Made in China for LECHPOL ELECTRONICS Sp. z o.o. Sp.k., ul. Garwolińska 1, 08-400 Miętne.

www.teesa.pl

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals