lionelo Truus Slim Safety Gate User Manual
- June 5, 2024
- lionelo
Table of Contents
lionelo Truus Slim Safety Gate
Dear Customer
In case of any questions or comments on the purchased product, please contact
us: help@lionelo.com.
Before using the product, please read the included user manual carefully
Producer:
BrandLine Group Sp. z o. o. ul. A. Kręglewskiego 1, 61-248 Poznań, Poland
IMPORTANT! READ AND FOLLOW THESE INSTRUCTIONS CAREFULLY AND KEEP THEM FOR
FUTURE REFERENCE
The barrier has a manual closing system.
WARNING
The barrier reaches its stiffness after proper assembly. Follow the
instructions below to install the product correctly.
GATE INSTRUCTION All parts
Note! The lock is apart when you open the carton, it is normal. Please screw
the 4 width adjusters when the lock is closed (fig.2).
Part list
- Baby gate
- two extensions 10 cm each
- plastic covers with 3M tape
- 4 screws.
Installation places
This product is suitable for indoor places, such as bedrooms, kitchens,
stairs, hallways, etc
- A gate is suitable for installation in the passages having a width of 75 cm to 85 cm. Installation in the wider aisles requires special extensions. The maximum width of the passage, which can be secured by using this barrier is 105 cm. Therefore, please use two additional extensions (10 cm each) which are included.
- Please make sure the setup surface is flat, strong, and stable.
- Please make sure the setup surface is larger than 3cm.
Installation instruction
- Insert 4 expansion bolts into the mounting holes on both sides of the railing (in the lower and upper part).
- Apply 3M tape to the flat part of the adapters and attach them to a mounting surface larger than 3 cm in diameter with screws. Then set the railing so that the expansion bolts are inside the plastic adapter (Fig. 4).
- The screws should be tightened so that the rubber washers fit tightly to the adapters and these to the mounting surface (Fig. 5).
- Screw the bottom adjusters, and let the gate stand vertical (fig. 6).
- Screw the top adjusters, and let the lock close smoothly (fig. 7).
- Check the 4 adjusters, and make sure the gate is set up firmly (fig. 8).
- Extensions installation (fig. 9).
Before you use the product, make sure the rail has been properly mounted.
Gate usage instruction
Way of open:
Press the two buttons and pull them down at the same time.
- Move the button indicated in the illustration (fig. 10).
- Then raise the movable element of the barrier (fig. 11).
- The gate can now be opened.
- open space 180° (fig. 12)
- two ways open gate can stop at 90 degrees (fig. 13)
Closing:
To close the barrier, close it manually until you hear a click (fig. 2). The
barrier is closed. If you are not sure if you heard a „click”, check manually
that the barrier is properly closed.
WARNINGS
- The railing is intended for children up to the age of 2.
- To prevent dangerous situations, please read this manual carefully before you start installing the railing.
- Rubber expansion bolt washers must fit tight to the assembly surface. For this reason, the railing is intended for flat surfaces only.
- WARNING – Safety railing must not be installed in windows.
- The product is intended for home use only.
- WARNING – The wrong installation may result in hazards.
- The product is intended for home use only.
- WARNING – Do not use the safety railing if any of its components is damaged or missing.
- If the safety railing is used downstairs, it is important that it is placed before the lowest level.
- If the child can climb the railing, please stop using the product.
- It is suggested that the safety railing is periodically checked to make sure it is safe and fully operational.
- Additional or spare parts must be purchased solely from the manufacturer or distributor.
- If the safety railing is used upstairs, it is suggested that it is not placed below the upper level.
- Before using, make sure the railing has been properly locked.
- Warning – never use without wall cups.
- Clean the product with a wet cloth.
The product has been tested and meets all the requirements of the: EN 1930:2011
All the pictures in the manual have been submitted for illustrative purposes only and are subject to change without prior notice.