lionelo Stefi Travel Bed User Manual

lionelo Stefi Travel Bed

Dear Customer
In case of any questions or comments on the purchased product, please contact us: help@lionelo.com

Note:
The assembly of the product must be performed by an adult. Failure to comply with this provision and the assembly instructions could result in serious injury or even death.

Producer:
BrandLine Group Sp. z o. o. ul. A. Kręglewskiego 1, 61-248 Poznań, Poland

IMPORTANT, RETAIN FOR FUTURE REFERENCE

WARNINGS

• Be aware of the risk of an open fire and other sources of strong heat, such as electric bar fires, gas fires, etc. in the near vicinity of the cot.
• Do not use the cot if any part is broken, torn, or missing, and use only spare parts approved by the manufacturer.
• Do not leave anything in the cot or place the cot close to another product, which could provide a foothold or present a danger of suffocation or strangulation, e. g. strings, blind/curtain cords.
• Do not use more than one mattress in the cot.
• The cot is ready for use only when the locking mechanisms are on. Before use, carefully check that these mechanisms are fully switched on.
• If you leave the child unattended in the crib, always make sure that the side entrance is fastened with a zipper.
• All mounting elements should always be tight, and connections should be regularly checked and tightened if necessary.
• The cot can not be used by children who can get out of it themselves, it may cause a fall and serious injuries or even death.
• The product is intended for children aged 0+ to 36 months and weighing up to 15 kg.
• WARNING – Only use the mattress sold with this cot, do not add a second mattress on this one, suffocation hazards.
• The mattress is an integral part of the bed.

Assembly instruction

1. Take the travel baby bed out of the bag and loosen the velcro straps. Place the bed on the floor and put the bag aside. Fig. 1.
2. Separate the legs pulling them apart. Keep the central lock-up. Otherwise, handrails will not fi t in the right place. Fig. 2
3. Pull the middle part of each top rail covered with material so that they fit into place. Start with the longer rails, and then the shorter ones. Fig. 3
4. Push the middle lock until the surface is completely flat Fig. 4
5. Place the mattress in the baby bed. Fig. 5

Note so that the sides of the cot/handrails are properly blocked, the central blockade of the floor must be raised upwards. The baby rails will not lock when the floor is unfolded.

Baby bed folding instruction

1. Remove all the bed accessories. Remove the mattress, canopy, organizer, and all the other accessories. Grasp the center handle located in the middle of the floor and pull it up. Fig. 6
2. To unlock the upper rails, press the indicated buttons on each side of them. Pull it slightly up and then push it down. Unlock the shorter sides first, and then do the same with the longer ones. Fig. 7
3. While still pulling up the handle, lift the floor of the baby bed and fold the legs. Fig. 8
4. Wrap the folded bed with the mattress and fasten it with Velcro straps. Put the folded baby bed into the bag. Fig. 9

Maintenance

The frame of the bed can be wiped with a damp cloth.

Clean the upholstery with a soft brush.

WARNING

• Only use the mattress sold with this cot, do not add a second mattress on this one, suffocation hazards
• The pictures in this manual are for illustrative purposes only.
• Therefore, they may differ from the actual product.

The product has been tested and meets all the requirements of the: EN 716-1:2017+AC:2019

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>