JULA 016233 LED Armatur Instruction Manual

: June 5, 2024
: JULA

Table of Contents

SAFETY INSTRUCTIONS
TECHNICAL DATA
INSTALLATION
Documents / Resources
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)

JULA 016233 LED Armatur
Instruction Manual

Important! Read the user instructions carefully before use. Save them for future reference. (Translation of the original instructions).
Care for the environment!
Recycle discarded products in accordance with local regulations.
Jula reserves the right to make changes. For the latest version of operating instructions, see www.jula.com

SAFETY INSTRUCTIONS

Disconnect the power supply before installation.
Check that the rated voltage corresponds to the main supply voltage.
Do not connect the product to the mains while it is still in the pack.
Check that all electrical cables comply with the applicable regulations and that they are connected in accordance with the instructions.
Never overload the mains. This can result in fire or a risk of electric shock.
Keep out of the reach of children.
Do not store the product in a very cold/hot place to avoid damaging the electronics.
The electronics in the product are sensitive to knocks and blows. Avoid dropping it.
Never attempt to replace damaged electrical cables yourself.
The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced.
The product is not dimmable.
Pay attention so that no concealed wires are damaged in connection with installation.
Be careful not to damage the insulation on the wires during installation. Make sure that the wires do not come into contact with sharp edges. Damaged insulation can result in a risk of electric shock.
Do not look directly into the light source.
The minimum safe distance to an illuminated object is 10 centimeters.
Products shall be installed in environments where an accumulation of conductive dust on the luminaire may be expected. For locations, the wiring system should be complied with EN 60364-4-42.

WARNING!
New installations and extensions to existing installations should always be carried out by an authorized electrician. If you have the necessary experience and knowledge (otherwise contact an electrician), you can replace power switches and wall sockets, fit plugs, extension cords, and light sockets.
Incorrect installation can result in fatal injury and the risk of fire.

Symbols

| Approved as per
applicable directives.
---|---
| Warning: Risk of electric shock.
| Class II.
| The condition to use the luminaires with limited outer surface temperature has been specified in EN 60598-2-24.
The luminaire cannot be used with the light source of a voltage more than l000V, due to the risk of combustible dust, which will not explode n the atmosphere but will accumulate on the luminaires, exists.
| Recycle discarded products as electrical waste.

TECHNICAL DATA

Rated voltage	230 V ~ 50 Hz
Output	44W
Safety class	II
Protection rating	IP65
Luminous flux	5000 Im
Color temperature	4000 K
CRI	80
Life span	25000 h
Off/On	20 000 times
Energy class	E
Dimmable	No
Diffusion angle	125°
Max number of lights connected in series	5