JULA 601021 Car Engine Stand Instruction Manual

JULA 601021 Car Engine Stand

SAFETY INSTRUCTIONS

Read these instructions carefully before use!

• Do not overload the engine stand. This can damage the stand and prevent it from working properly.
• The engine stand should only be used on hard, flat surfaces that can support the weight of the stand and its load. The stand may tip over otherwise.
• Check that the engine is centred and secured to the head plate (4). Off-centered loads can cause the engine and handle to rotate in either direction when the rotating mechanism lock is released.
• Lock the head plate rotating mechanism before placing an engine on the stand. Unlock the rotating mechanism slowly and carefully.
• The stand and/or adapters must not be modified in any way.
• Failure to follow these instructions may result in damage to the stand and/or engine and serious personal injury.

DESCRIPTION

1. Upright
2. Front crossbar with wheels
3. Bolt M12 x 80
4. Head plate
5. Lock pin
6. Mounting arm
7. Bolt M12 x 50
8. Flat washer 12 mm
9. Hex nut M12
10. Locking washer 12 mm
11. Rear swivel caster 3.5”
12. Flat washer 14 mm
13. Lock ring
14. Centre beam
15. Rear crossbar
16. Type plate
17. Front wheel 4”
18. Bolt M8 x 20
19. Lock washer 8 mm
20. Nut M8

ASSEMBLY

1. Attach the upright (1) and the centre beam (14) to the front crossbar (2) with a M12 x 80 bolt (3) and lock washer (10) from underneath. Tighten the bolt through the nut that is welded onto the centre beam.
2. Attach the rear crossbar (15) to the centre beam (14) with M12 x 80 bolts (3), flat washers (8), lock washers (10) and M12 hex nuts (9).
3. Fit the head plate (4) to the upright. Align the holes and slide in the lock pin (5).
4. Attach the four mounting arms (6) to the head plate with four M12 x 50 bolts (7), four flat wahers (8), four lock washers (10) and four M12 hex nuts (9).

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>