Craft Supplies ER32 Apprentice Collet Chuck Instructions
- May 15, 2024
- CRAFT SUPPLIES
Table of Contents
Craft Supplies ER32 Apprentice Collet Chuck
Product Information
Specifications:
- Product Name: Apprentice Collet Chuck
- Collet Type: ER32
Product Usage Instructions
Installing the Collet:
- When looking at the inside of the collar, the hole inside is offset. This is what centers and locks the collet in place. Press the collet into collar until the collet flange slips into the undercut of the collar, it will make a distinct snap. Verify the face of the collet is flush with face of the collar. Now install the Collet/Collar combo into the collet body and tighten. Use Diagram 1 to verify correct assembly.
- To remove the collet, unscrew the collar and remove the collet/collar combo. Push the collet out of the collar, if it seems stuck you can angle it in the direction of the offset hole.
- Initial installation of the collet may seem stiff but will soften up over time.
Components:
- Collet Body
- ER32 Collet
- Collar
- Apprentice Collet Chuck
FAQs
-
Q: How do I know if I have installed the collet correctly?
A: To verify correct installation, ensure that the collet flange is securely locked into the undercut of the collar and that the face of the collet is flush with the face of the collar as shown in Diagram 1. -
Q: What should I do if the collet seems stuck during removal?
A: If the collet appears stuck during removal, try angling it in the direction of the offset hole to facilitate its release from the collar.
Installing the Collet
- When looking at the inside of the collar, the hole inside is offset. This is what centers and locks the collet in place. Press the collet into collar until the collet flange slips into the undercut of the collar, it will make a distinct “snap”. Verify the face of the collet is flush with face of the collar. Now install the Collet/Collar combo into the collet body and tighten. Use Diagram 1. to verify correct assembly.
- To remove the collet, unscrew the collar and remove the collet/collar combo. Push the collet out of the collar, if it seems stuck you can angle it in the direction of the offset hole.
- Initial installation of the collet may seem stiff but will soften up overtime.
1-800-551-8876
www.woodturnerscatalog.com
© 2023 Craft Supplies USA. All rights reserved.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>