JULA 422222 Outdoor Fitting Instruction Manual

June 4, 2024
JULA

JULA 422222 Outdoor Fitting

JULA-422222-Outdoor-Fitting-product-imageJula reserves the right to make changes.
For latest version of operating instructions, see www.jula.com

SAFETY INSTRUCTIONS

Read these instructions carefully before use!

  • Be careful when screwing the bulb into the lamp base. The bulb will break if handled carelessly.
  • If you are not sure about the installation or encounter problems, call an authorized electrician.
  • Check that the power supply is disconnected before you start the installation.
  • NOTE: Do not use the fitting if the power cord and/or plug are damaged in any way. For safety reasons, the power cord must only be replaced or repaired by an authorized service center. Consult your dealer.
INSTALLATION
  1. Remove the backpiece from the fitting.
  2. Use the backpiece as a template in order to mark the drill holes on the wall where the fitting is to be mounted. Drill the holes and insert the wall plugs supplied.
  3. Take the lamp glass sections out of the protective packaging.
  4. Put the glass sections in position ( figure 1). Be very careful not to pull the glass sections too hard as they will break.
  5. Remove the casing beneath the lamp to access the terminal block ( figure 2 ). Push the power cord from the mains power supply through the watertight bushing underneath the backpiece.
  6. Screw the bulb in the lamp base.
  7. Fit the lamp housing on the backpiece using the screw supplied. Take care to align the lamp housing correctly before tightening the screw.

Figure 1

Routing The Wires
Colour of fitting’s mains wire

  • Blue wire, connects to:
  • Green/yellow wire, connects to:
  • Brown wire, connects to:

JULA-422222-Outdoor-Fitting-02

Figure 2

Colour of household’s mains wire

  • Blue or black wire (neutral)
  • Green/yellow wire (earth)
  • Red or brown wire (live)
MAINTENANCE

Replacing the bulb

  • Always disconnect from the mains power supply and leave the bulb to cool for 10 minutes before replacing the bulb.
  • Replacement bulb:
    Output: see base.
    Type: see base.

Cleaning
Use a soft, dry cloth to clean the outside of the fitting.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals