JULA 733006 Fountain Instruction Manual
- June 5, 2024
- JULA
Table of Contents
JULA 733006 Fountain
-
Care for the environment!
Recycle discarded product in accordance with local regulations. -
Jula reserves the right to make changes.
For latest version of operating instructions, see www.jula.com
SAFETY INSTRUCTIONS
Read the Operating Instructions carefully before use!
- The pump must not be used by children. This is not a toy.
- Make sure the pump is disconnected from the mains when cleaning or servicing.
- Only use with clean water. No other fluids may be used.
- The pump must not run dry.
- The pump must be connected to an earthed mains supply.
- The pump must not be used if the water temperature is above +30°C.
- The pump must not be used if there is a risk that the water will freeze.
- Make sure that the water cannot run along the power cord into the mains outlet.
- The pump must not be lifted, carried or pulled by the power cord.
- The pump must not be used if it is damaged.
- The power cord must not be replaced.
- The fountain consists of 2 parts.
TECHNICAL DATA
- Mains voltage : 230 V/50 Hz
- Transformer : 12 V AC
- Output power ; 18 W
- Power : 0.25 A
- Protection rating: IP68
- Safety class : III
- Pressure height : 1,800 mm
- Water flow : 18.3 l/min
- Power cable, ; length 18m
DESCRIPTION
OPERATION
Water level
Use
Fill the water to the required level. Start by connecting the discharge line
to the pump and then the pump’s power cord to the mains supply. You can now
start the pump.
Keep the water clean
Check the water at regular intervals. This is to prevent turbidity and micro-
organisms.
MAINTENANCE
Cleaning
Make sure the pump is not connected to the mains supply. Use a soft brush
or hold the pump under running water to remove any dirt.
TROUBLESHOOTING
The pump must not be connected to the mains supply when troubleshooting.
The pump will not run
- Make sure the pump’s power switch is in the ON position.
- Check that the wall socket is working.
- Try connecting the pump to another wall socket.
- Check that the pump or hose is not clogged.
- Check that the hose is not bent.
- Check that the impeller is not damaged or jammed.
Noisy pump
- Make sure the water level is adequate.
- Check that the impeller is not blocked.
- Rinse the impeller housing with clean water.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>