JULA 601024 Axle Stand Instruction Manual
- June 4, 2024
- JULA
Table of Contents
JULA 601024 Axle Stand
SAFETY INSTRUCTIONS
Read these instructions carefully before use!
- Failure to follow the warnings below can result in the load falling off and the axle stands becoming damaged, which can cause serious injury and other damage.
- Never exceed the rated load capacity of the axle stands (see Technical Data).
- Place the load on the centre of the saddle.
- Always place the axle stands in pairs on a hard, level surface that can support the load. The stands will not be stable if placed on soft surfaces. This can cause the load to fall off and cause injury.
- The stands must not be modified in any way due to the safety hazards that arise if the stands are used incorrectly.
- Inspect the axle stands before each use for cracks, cracked welds and missing or damaged parts. Any stand that appears to be damaged in any way must not be used.
TECHNICAL DATA
- Capacity (kg) 2000
- Min. height (cm) 26.51
- Max. height (cm) 41.75
- Base size (cm) 19.05 x 17.46
DESCRIPTION
OPERATION
- Refer to your vehicle owner’s manual for proper jacking procedures.
- Position the axle stands under the vehicle at the specified lifting points.
- To adjust the axle stands: Hold the control lever up while adjusting the axle stands to the height required. Push the control lever down to lock the pawl into the teeth located in centre column. Make sure the pawl is fully engaged into the teeth.
- Carefully lower the load onto the stands
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>