Alphacool Geforce RTX 3090 TI Strix/TUF GPU Water Cooler Instructions

Alphacool Geforce RTX 3090 TI Strix/TUF GPU Water Cooler

Accessories

Compatibility check

Before starting the cooler assembly, compare your card with the pictures in our configurator. To do so, visit https://www.hwconfig.com and search for your graphics card or cooler model. For a definitive identification, you can also compare the PCB number. The cooler was designed for a special PCB layout. Occasionally, graphics card manufacturers may revise the design of their card slightly, causing the cooler not to fit on later models. During assembly, please make sure taller parts have enough space around them and that the cooler does not damage your graphics card. Alphacool International GmbH is not liable for assembly errors occurring due to negligence, such as selecting an incompatible cooler.

Prepare graphics card

Put the hardware on an antistatic mat. Begin dismantling the original cooler. Depending on the structure of the cooler, remove the screws at the back of the card and carefully unhook the fan connector first. If the original cooler uses thermal glue, extreme care should be taken as you can easily damage parts. Pick up all the items carefully. Next, clean the hardware of thermal paste or pad residues with a solvent (e.g. isopropanol alcohol).

Mounting the front pads

Clean the contact surfaces on the bottom side of the cooler with isopropanol or similar. The surface must be free of contaminants. Remove the protective foils from the thermal pads and place the pads on the copper block as shown.

Applying thermal paste

With the help of a plastic strip or similar spread a thin layer of thermal paste on the GPU. The layer should be less than a millimeter thick, otherwise the surrounding components may be contaminated.

Mounting the graphics card

Place the graphics card on the prepared cooler. Fasten the card as shown with the 4 M2x5 screws with M2 washers. Hand-tighten the screws crosswise, one turn at a time.

Mounting the back pads

Remove the protective foils from the thermal pads and place the pads on the PCB as shown.

Mounting the backplate

Put the backplate on and screw it together with the 8 M2x11 screws as shown.

Connecting the LED

To control the digital – RGB lighting, connect the included adapter to the 3 – pin female connector and plug it to a digital – RGB controller (e.g. Alphacool Aurora Eiscontrol, Art.: 15360, not included). You can connect additional digital -RGB LEDs to the remaining 3 – pin male connector.

Connecting the LED

Close the inlets which you do not need for tubing. Screw in the screw plugs with the enclosed tool.

Alphacool International GmbH Marienberger Str. 1 D-38122 Braunschweig Germany
Support: +49 (0) 531 28874 – 0 Fax: +49 (0) 531 28874 – 22
E-mail: info@alphacool.com https://www.alphacool.com
V. 1.00-05.2022

References

• HWConfig - German
• Alphacool - Your water cooling specialist
• HWConfig - German

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>