Alphacool Eisblock Aurora GPX-N ACRYL Installation Guide
- June 4, 2024
- ALPHACOOL
Table of Contents
Alphacool Eisblock Aurora GPX-N ACRYL Installation Guide
Accessories
| | | | |
---|---|---|---|---|---
1x 15x15x1mm
| 2x 15x51x1mm| 1x 15x38x1mm| 1x 30x30x2mm| 2x 8x100x3mm|
1x 30x30x3mm
| |
|
8x M2x11 Screws| 2x Screw plugs| 2x MCX Fitting plugs|
1x Too
COMPATIBILITY CHECK
Before starting the cooler assembly, compare your card with the pictures in
our configurator. To do so,visit https://www.hwconfig.com and search for
your graphics card or cooler model. For a definitive identification, you can
also compare the PCB number. The cooler was designed for a special PCB layout.
Occasionally, graphics card manufacturers may revise the design of their card
slightly, causing the cooler not to fit on later models. During assembly,
please make sure taller parts have enough space around them and that the
cooler does not damage your graphics card.
Alphacool International GmbH is not liable for assembly errors occurring
due to negligence, such as selecting an incompatible cooler.
PREPARE GRAPHICS CARD
Put the hardware on an antistatic mat. Begin dismantling the original cooler. Depending on the structure of the cooler, remove the screws at the back of the card and carefully unhook the fan connector first. If the original cooler uses thermal glue, extreme care should be taken as you can easily damage parts. Pick up all the items carefully. Next, clean the hardware of thermal paste or pad residues with a solvent (e.g. isopropanol alcohol).
Induction
Clean the contact surfaces on the bottom side of the cooler with Isopropanol
alcohol or similar. The surface must be free of contaminants.
Remove the protective foils from the thermal pads and place the pads on the
backplate as shown.
Put the active backplate on and screw it together with the 8 M2x11 screws as
shown.
To control the digital RGB lighting, connect the 3-pin female connector to the 3-pin male connector of the graphics card LED. You can connect additional digital RGB LEDs to the remaining 3-pin male connector. As shown, you have two installation options.
Two options are available to connect the unit to the water circuit. Use either
the two G1/4″ threads or the 5/3mm connections in conjunction with the
optionally available MCX distributor with article number 13041.
Close the 3mm barbed fittings with the enclosed cap. Screw in the G1/4 screw
plugs with the enclosed tool.
Support
Alphacool International GmbH
Marienberger Str. 1
D-38122 Braunschweig
Germany
Support: +49 (0) 531 28874 – 0
Fax: +49 (0) 531 28874 – 22
E-Mail: info@alphacool.com
https://www.alphacool.com
General Managers: Andreas Rudnicki, Nathanael Draht, Fabian Noelte
WEEE-Reg.-Nr.: DE 54464644
Trade Register: Amtsgericht Braunschweig HRB 202390
VAT.ID.Nr.: DE270458421
Tax number: 13/207/02047
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>