Room Board Harvey Solar Light Instruction Manual
- June 12, 2024
- Room Board
Table of Contents
Room Board Harvey Solar Light
Product Information
The Harvey Solar Light is a solar-powered outdoor light that provides illumination for your outdoor spaces. It includes a solar module for charging the batteries and an aluminum housing to protect the module. The light is designed to be installed in locations with a minimum of 7 hours of direct sunlight for optimal performance. It is recommended to avoid areas with fertilizer, machinery, or heavy foot traffic to ensure the longevity of the light.
Product Usage Instructions
- Prior to installation, place the solar module in direct sunlight for a minimum of 7 hours to charge the batteries and enable programming of the settings.
- Remove any mulch and rocks around the desired light location.
- Using a rubber mallet and a 3/4-inch PVC pipe or stake, make a hole in the ground that will fit the light’s stake.
- Insert the stake into the ground so that the threaded base is just above the ground. Do not pack the soil around it yet.
- Place the charged solar module into the aluminum housing. Tighten the single screw on the side of the housing to secure the solar module.
- Program your desired settings using the provided instructions.
- Place the light onto the ground stake and spin it to tighten it onto the stake’s threaded base.
- Adjust the light’s position as needed before tightly packing the soil around it.
- Rearrange rocks and mulch to complete the installation.
For any further assistance or inquiries, please contact customer support at 800.486.6554 or visit our website at roomandboard.com.
DIMENSION
Recommended Tools
- Rubber mallet
- 3/4″-1″ plastic conduit such as PVC pipe
This Product Includes
- Aluminum housing
- Removable solar module
- Stake
Installation Instructions
Note: Prior to installation, place the solar module in direct sunlight for a minimum of 7 hours to charge the batteries so you can program the settings. For best performance, place lights in locations with a minimum of 7 hours of direct sun. Try to avoid areas with fertilizer, machinery or heavy foot traffic.
- Remove mulch and rocks around desired light location.
- Use a rubber mallet and a 3/4-inch PVC pipe or stake to make a hole in the ground that will fit the light’s stake.
- Stick the stake into the ground so the threaded base is just above ground. Do not pack the soil around it yet.
- Place the charged solar module into the aluminum housing. Tighten the single screw on the side of the housing to secure the solar module.
- Program your desired settings.
- Place the light onto the ground stake. Spin it to tighten it onto the stake’s threaded base.
- Adjust the light’s position as needed before tightly packing the soil around it, then rearrange rocks and mulch.
CONTACT
WEB:roomandboard.com
TELL: 800.486.6554
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>