Marathon Lighting ML-5573 24W Color Selectable LED Wall Mount Installation Guide
- June 15, 2024
- Marathon Lighting
Table of Contents
Installation Guide
LED Lighting Fixture
SAVE THESE INSTRUCTIONS
ML-5573 24W Color Selectable LED Wall Mount
BEFORE YOU BEGIN
Read and follow all safety instructions
WARNING
RISK OF FIRE, EXPLOSION AND ELECTRIC SHOCK
- This product should be installed, inspected, and maintained by a qualified electrician only ,in accordance with the NEC (National Electric Code) and all local codes.
- Turn off electrical power before inspection, installation or removal.
- Use only UL (or other NTRL) approved wire for input/ou tput connections.
- Minimum size 18 AWG or 14 AWG for continuous runs.
- Make sure LEDs and drivers are cool to touch when performing maintenance.
- Make sure the supply voltage is the same as the rated voltage of the luminaire.
- Do not install in a hazardous atmosphere, except where the ambient temperature does not exceed the rated operating temperature of the fixture.
- Keep tightly closed when in operation
Prepare Electrical Wiring
Electrical Requirements
- The LED driver must be supplied with the voltage specified on the product label and connected to an individual, properly grounded branch circuit protected by a 20 Ampere circuit breaker. Use min. 75°C supply.
Grounding Instructions
- The grounding and bonding of the overall system shall be done in accordance with NEC Article 600 and local codes
LED Wallpack
Before starting:
- Ensure that the supply power is shut off.
- Unpack the fixture and ensure that there are no damaged or missing parts.
- NOTE: Fixture may be sealed where it contacts the mounting surface with a siticone sealant.
Tools Required:
Screw driver
Orill with assorted bits
Wire Strippers
Wire Cutters Step 1: Locate the four screws which attach the front assemblyto
the back mounting plate.
Step 2: Remove thescrews and separate the front assembly from the back
mounting plate.
Step 3: Mark the location for the screw holes on the back plate. Drill the
holes and attach the plate to the the junction box with the appropriate
hardware (not included}
Step 4: Make the wiring connections according to the wiring diagram on Page 4
Push excess wire into the junction box.
Step 5: Reassembie the front assembly to the back mounting plate using the
four screws removed in Step 6: Restore power and check that the fixture
functioning properly.
Electrical Wiring Diagram
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>