American Standard 1582 Series Townsend Freestanding Bathtub Overflow Cover and Drain Kit Instruction Manual

June 4, 2024
American Standard

American Standard 1582 Series Townsend Freestanding Bathtub Overflow

Cover and Drain Kit

American-Standard-1582-Series-Townsend-Freestanding-Bathtub-Overflow-Cover-
and-Drain-Kit-PRODUCT

DRAIN KIT

Model : 1582.000.YYY FOR FREESTANDING TUB 2691, 2692
Model : 1582.200.YYY FOR FREESTANDING TUB 2549

Thank you for selecting American Standard…the benchmark of fine quality for over 100 years. To ensure that your installation proceeds smoothly–please read these instructions carefully before you begin.

BEFORE YOU BEGIN

Local building codes vary by location. Observe all local plumbing and building codes. Your new bath is shipped to you after careful inspection. To insure maximum performance and pleasure from this product, please follow the instructions and cautions.

NOTE : Take extra care in handling surfaces of the bath. Use only non- abrasive cloths to avoid scratching.

TOOLS & MATERIALS MAY BE REQUIRED

TOOLS:

  • Level
  • Square
  • Tape Measure
  • Pipe Wrench
  • Slip Joint Pliers
  • Personal Safety Equipment
  • Caulking Gun

MATERIALS:

  • Silicone Caulking
  • Tub & Tile Caulk

KIT INCLUDES

American-Standard-1582-Series-Townsend-Freestanding-Bathtub-Overflow-Cover-
and-Drain-Kit-FIG-1

Snap “Overflow” cover into overflow of tub. Ensure it is securely in place. (See Fig. 1)

NOTE : Skip this step for kit 1582.200

Install drain as shown in Tighten drain nut using a pipe wrench and plug wrench. Make sure all of the silicone seals are in the proper location (as shown in Fig. 2) and there is no water leaking.

INSTALLING THE 1-1/2″ DIAMETER TAIL PIECE ASSEMBLY INTO P-TRAP
A slip-joint nut and a flanged, 1-1/2″ diameter tail piece are recommended. (See Fig. 3) Slide the slip-joint nut over tail piece towards the flanged end as shown. Slide the P-trap slip-joint nut and seal over the tail piece as shown. Insert the tail piece into the P-trap. The flange of the tail piece should be approximately 2″ (51mm) above the finished floor when fully inserted to the P-trap. The tail piece can be cut if necessary.

American-Standard-1582-Series-Townsend-Freestanding-Bathtub-Overflow-Cover-
and-Drain-Kit-FIG-4

Install the tub by following the instructions included with the tub.

In the United States:
American Standard Brands 1 Centennial Ave. Piscataway, New Jersey 08854 Attention: Director of Customer Care For residents of the United States, warranty information may also be obtained by calling the following toll free number: 800-442-1902 www.americanstandard.com

In Canada:
AS Canada, ULC 5900 Avebury Rd. Mississauga, Ontario Canada L5R 3M3 Toll Free: 800-387-0369 www.americanstandard.ca

In Mexico:
American Standard B&K Mexico S. de R.L. de C.V. Via Morelos #330 Col. Santa Clara Ecatepec 55540 Edo. Mexico Toll Free: 01-800-839-1200 www.americanstandard.com.mx

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

American Standard User Manuals

Related Manuals