Marathon Lighting ML-WM-8273 LED Wallpack Installation Guide
- June 16, 2024
- Marathon Lighting
Table of Contents
LED Lighting Fixture
Installation Guide
ML-WM-8273 LED Wallpack
SAVE THESE INSTRUCTIONS
BEFORE YOU BEGIN
Read and follow all safety instructions
WARNING
RISK OF FIRE, EXPLOSION AND ELECTRIC SHOCK
- This product should be installed, inspected, and maintained by a qualified electrician only in accordance with the NEC (National Electric Code) and all local codes.
- Turn off electrical power before inspection, installation or removal.
- Use only UL (or other NTRL) approved wire for input/ou tput connections.
- Minimum size 18 AWG or 14 AWG for continuous runs.
- Make sure LEDs and drivers are cool to touch when performing maintenance.
- Make sure the supply voltage is the same as the rated voltage of the luminaire.
- Do not install in a hazardous atmosphere, except where the ambient temperature does not exceed the rated operating temperature of the fixture.
- Keep tightly closed when in operation
Prepare Electrical Wiring
Electrical Requirements
- The LED driver must be supplied with the voltage specified on the product label and connected to an individual, properly grounded branch circuit protected by a 20
Ampere circuit breaker. Use min. 75°C supply.
Grounding Instructions
- The grounding and bonding of the overall system shall be done in accordance with NEC Article 600 and local codes
LED Wallpack
Before starting:
- Ensure that the supply power is shut off.
- Unpack the fixture and ensure that there are no damaged or missing parts.
- NOTE: Fixture must be sealed where it contacts the mounting surface with a silicone sealant.
Tools Required:
Phillips Screwdriver
Hex Key Set
Wire Strippers
Wire Cutters
Step 1: Loosen the two (2) set screws found on the bottom of the fixture
housing.
Step 2: Remove the quick mount bracket from the fixture and attach it to
the junction box with the appropriate hardware (not included).
Step 3: Make the wiring connections according to the wiring diagrams on
Page 4. Push excess wire into the junction box.
Step 4: Lift the fixture and tilt slightly toward the quick mount
bracket. Hook the fixture housing onto the quick mount bracket as shown. Take
care not to pinch any wires.
Step 5: Tighten the two (2) set screws to secure the fixture housing to
the quick mount bracket.
Step 6: Restore power and check that the fixture is functioning properly.
Electrical Wiring Diagram
Documents / Resources
|
Marathon Lighting ML-WM-8273 LED
Wallpack
[pdf] Installation Guide
ML-WM-8273 LED Wallpack, ML-WM-8273, LED Wallpack, Wallpack
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>