universal douglas LSA-25WH LED Chain Instruction Manual
- June 3, 2024
- universal douglas
Table of Contents
universal douglas LSA-25WH LED Chain
For Wet, Damp and Dry locations
Equipment Needed
- Wire stripper
- Manual screwdriver, rivet gun or powered screwdriver and bit
- Tape measure
Components Needed
- Cleaning cloth
- Non-petroleum-based cleaner
- Non-water-based silicone
- IDC or butt splice connectors that accept 20 AWG wire
- Wire nuts that accept 18-20 AWG wire
- UL recognized 18 AWG supply wire
- 6 pan head sheet metal screws or 1/8” rivets
- Universal Douglas LED strip
- Universal Douglas 2 Volt, Class 2 Power Supply
WARNING
To avoid electric shock or fire: Disconnect power at service panel prior to
installation, troubleshooting or maintenance. Always follow NEC and local
wiring requirements. Properly ground power supply and fixture. Do not connect
output of power supplies in series or parallel. All LED module wire
connections are white to white and red to red. Power supply to LED module
connections are red to red and black to white. Operating temperature -40ºC to
70ºC
- Step 1 Layout the design and test on a sample letter. For layout support use chart 1 below or contact Universal Douglas Technical Support at 1-800-225-5278.
- Step 2 Clean letters with a non-petroleum-based product and let dry. Arrange LED strips inside the letter.
- Step 3 Peel off the tape backing and place the LED modules into the desired location. Use an area on the LED module other than the LED to apply pressure. Secure module as needed with #6 pan head sheet metal screws or 1/8” rivets.
- Step 4 Make connections between LED strips using IDC connectors, butt splices or wire nuts. Wires can be cut or connected between any LED module. Modules can be arranged in series or parallel.
- Step 5 Cover open wire ends using wire nuts and non-water-based silicone to prevent the connections from touching the sign.
- Step 6 Drill access holes where required for the power supply wires. Connect the red wire from the power supply to the red wire on the LED strip. Connect the black wire from the power supply to the white wire on the LED strip.
Trouble Shooting
Chart 1
Recommended Rows of LED Strips for Different Stroke Lengths (for channel can
depth of 5” or deeper)
Chart 2
Mounting Distance from Power Supply to LED Chain
IT’S EASY TO REACH US…
Universal Douglas 51 Century Blvd., Suite 230 Nashville, TN 37214-3683 General
Info: 1-800-862-8666 For Technical
Engineering Services (TES), application support and warranty information, call
1-800-225-5278
- Website : www.universaldouglas.com
- Email : webmaster@universaldouglas.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>