AMAX LED-RSM8DL WT Radar Sensor Integrated LED Recessed Light Kit User Manual
- June 3, 2024
- AMAX
Table of Contents
AMAX LED-RSM8DL WT Radar Sensor Integrated LED Recessed Light Kit
TOOLS AND MATERIALS REQUIRED
SAFETY PRECAUTIONS
- TURN OFF THE ELECTRICAL POWER BEFORE STARTING THE INSTALLATION OF THE LIGHT FIXTURE.
- THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A CERTIFIED
- ELECTRICIAN FAMILIAR WITH LOCAL MUNICIPAL CODES AND REQUIREMENTS.
- CONSULT A QUALIFIED ELECTRICIAN TO ENSURE THE CORRECT BRANCH CIRCUIT CONDUCTOR.
The radar sensor turns off the light after 17 seconds of no detection and back on as the user re-enters the workplace from 4.5-5.5 yards away. Back Convex Dimension: 2 1/8″x5/8″
WARNING
Wet-rated lighting fixtures are used in places with direct exposure to water.
These locations include almost all outdoor lights, including landscape
lightings such as path lights and ground wells. Fixtures rated for wet
locations use waterproof seals to protect their internal components from
moisture. This does
not cover the section where the light is mounted to the junction box. If water
is entering through the junction box, it will enter the light fixture, and
that is classified as an electrical Hazzard by most municipal and fire
departments. Customer service:
888-945-5221 Do not return to the
store.
- Prior to installation, install a mounting plate into the electrical junction box with mounting screws. Drive screws completely to the end of the junction box.
- Connect supply wires to wires on a fixture with wire nuts. Connect white to white, black to black, and ground wire to ground wire as grounding connection.
- Complete the installation by pushing the fixture spring clips towards the opening in the mounting plate installed on the junction box.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>